Husqvarna 15V2 manual Stopping the engine, Release lever

Page 21

DRIVING

WARNING!

Never drive the machine on ground with a slope of more than 15°. Mow slopes upwards and downwards, never across. Avoid sudden changes in direction.

MAX 15

Stopping the engine

Preferably allow the engine to idle for a minute to obtain normal working temperature before stopping it if it has been working hard. Avoid idling the engine for long periods, as there is a risk of carbon build-up on the spark plugs.

1.Lift up the cutting unit by pulling the lever back to the locked position.

2.Move the throttle control to the MIN. position. Turn the ignition key to the STOP.

3. When the Rider is at a standstill, press down the

parking brake and push in the locking button.

Release lever

The release control must be pulled out in order for the Rider to be moved when the engine is shutoff.

English – 19

Image 21

Contents English RiderSvenska Contents Dear customer IntroductionTravel and transport on public roads TowingSerial number Good serviceExplanation of Symbols General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Choke lever Throttle controlSpeed limiter Parking brakeLift lever for cutting unit Cutting unitLever for adjustment of cutting height SeatFuelling Driving Before startingStarting the engine Driving Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval Hours Before start 100 200Engine hood Removing the machine hoodsFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Checking and adjusting the choke wireReplacing the fuel filter Varning Replacing the air filterCheck the level of the battery acid Checking of the fuel pump’s air filterFitting the wrong spark plug type can damage the engine Inspecting the safety system Main fuse Checking the tyre pressureChecking the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Installing BioClipChecking and adjusting the cutting unit’s ground pressure Belt replacement on BioClip Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit beltBelt change on Combi Maintenance Placing in service position Service position for the cutting unitMaintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, CombiChecking the engine’s oil level LubricationChanging the oil filter Changing the oilLubricating the belt adjuster Checking the transmission’s oil levelGeneral lubrication Problem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage CoverTechnical Data EU declaration of conformity Only applies to Europe Service Journal Pre-delivery serviceWork done Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01