Husqvarna 15V2 manual Maintenance

Page 35

MAINTENANCE

4. Useful hint: Mark the positions of the blades on the respective pulley using a felt-tip pen.

Loosen the three bolts 1/2 - 1 turn. Press the sides of the belt together to give maximum slack and tighten one of the bolts. Replace the belt and tighten as shown (see decal on cover). Set the blades at 90º to each other and loosen the bolt again. The spring ensures the correct belt tension. Check the positions of the blades again and adjust if necessary by repositioning the belt on the teeth. Tighten the three bolts to

45 Nm/32 lbft.

IMPORTANT INFORMATION

The blades on a Combi 103 unit should be set at 90 degrees to each other. In all other cases the blades can collide and cause serious damage to the cutting unit.

5. Fit the protective cover over the belts and replace the parallelism arm.

Belt change on cutting unit with rear ejection, side ejection and Combi 112

On these cutting units with “collision-proof” blades, the blades are driven by one V-belt. Do as follows to change the V-belt:

1.Remove the cutting unit.

2.Undo the bolt on the lift strut and the two screws on the cover. Lift the cover off the cutting unit.

3.Loosen the spring (4) that tensions the V-belt and pry off the belt.

Simply reverse the procedure to fit the new belt.

English – 33

Image 35
Contents English RiderSvenska Contents Towing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceExplanation of Symbols General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle controlChoke lever Speed limiterLift lever for cutting unit Cutting unitFuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting Driving Driving the machine Cutting tips Release lever Stopping the engineHours Before start 100 200 MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removing the machine hoodsEngine hood Front hoodPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacing the fuel filter Checking and adjustment of the throttle wireChecking and adjusting the choke wire Varning Replacing the air filterFitting the wrong spark plug type can damage the engine Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the engine’s cooling air intake Main fuseChecking the tyre pressure Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Installing BioClipChecking and adjusting the cutting unit’s ground pressure Replacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelismBelt change on Combi Maintenance Placing in service position Service position for the cutting unitMaintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, CombiChecking the engine’s oil level LubricationChanging the oil filter Changing the oilGeneral lubrication Lubricating the belt adjusterChecking the transmission’s oil level Problem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data EU declaration of conformity Only applies to Europe Work done Service JournalPre-delivery service Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01