Husqvarna 15V2 manual Explanation of Symbols

Page 6

EXPLANATION OF SYMBOLS

These symbols are on the machine and in the operator’s manual.

Study them carefully so that you know what they mean.

Read the operator’s manual

R N

Reverse

Neutral

Fast

Slow

Engine off

Battery

Choke

Fuel

Oil level

Cutting height

Backwards

Forwards

Ignition

Hydrostatic free wheel

Use hearing protection

Parking brake

Brake

Warning

Noise emission to surroundings in accordance	Warning!	Warning!	Never drive across a	CE conformity
with the directive of the European Community. The	Rotating blades.	Risk that the machine	slope	marking
machine’s emission is indicated in the chapter		can tip over
TECHNICAL DATA and on the decal.

Never use the machine if persons, especially	Never carry passengers on the
children, or animals, are in the vicinity.	machine or equipment.

Starting instructions Read the instructions Check the engine’s oil level Check the hydrostat’s oil level Lift up the cutting unit

Put the hydrostat pedals in the neutral position

Brake

If the engine is cold use the choke Start the engine

Release the parking brake before driving

Keep hands and feet away	Drive very slowly without
from under the hood when	the cutting unit.
the engine is running.

Speed limiter pedal forwards

Neutral

Speed limiter pedal reverse

Switch off the engine and take off the ignition cable before repairs or maintenance

4 – English

Image 6

Contents Rider EnglishSvenska Contents Travel and transport on public roads IntroductionDear customer TowingGood service Serial numberExplanation of Symbols Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle controlChoke lever Parking brakeCutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Driving Before startingStarting the engine Driving Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule Hours Before start 100 200Front hood Removing the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Checking and adjusting the choke wireReplacing the fuel filter Replacing the air filter VarningCheck the level of the battery acid Checking of the fuel pump’s air filterFitting the wrong spark plug type can damage the engine Inspecting the safety system Main fuse Checking the tyre pressureChecking the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handInstalling BioClip Removing the cutting unitChecking and adjusting the cutting unit’s ground pressure Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitBelt replacement on BioClip Replacing the cutting unit beltBelt change on Combi Maintenance Service position for the cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip 90, Combi Removal of BioClip plug CombiLubrication Checking the engine’s oil levelChanging the oil Changing the oil filterLubricating the belt adjuster Checking the transmission’s oil levelGeneral lubrication Trouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data EU declaration of conformity Only applies to Europe Service Journal Pre-delivery serviceWork done Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01