Husqvarna 15V2 manual Fitting the cutting unit, Observe caution to avoid trapping your hand

Page 30

MAINTENANCE

Fitting the cutting unit

WARNING!

Wear protective glasses when fitting the cutting unit. The collet spring which tensions up the belt can go off and cause personal injury.

1.Place the Rider on a flat surface and apply the parking brake. Check that the lever for setting the cutting height is in the lowest position.

Make sure the support wheels are fitted to the cutting unit (1).

2.Grasp the handle at the front or hold the frame of the cutting unit (2) and slide the unit underneath the rider mower.

Make sure that the tongue (3) on the cutting unit engages correctly.

3. Insert the bolt and secure it with a locking pin.

WARNING!

Observe caution to avoid trapping your hand.

4.Press down the frame and insert the pin. Fit the drive belt around the drive wheels of the cutting unit.

5.Hook up the height adjustment strut.

3

1

2

28 – English

Image 30

Contents Rider EnglishSvenska Contents Travel and transport on public roads IntroductionDear customer TowingGood service Serial numberExplanation of Symbols Safety Instructions General useKeep children away from the area to be mowed Driving on slopes Proceed as followsMaintenance ChildrenDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Speed limiter Throttle controlChoke lever Parking brakeCutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Driving Before startingStarting the engine Driving Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule Hours Before start 100 200Front hood Removing the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Checking and adjusting the choke wireReplacing the fuel filter Replacing the air filter VarningCheck the level of the battery acid Checking of the fuel pump’s air filterFitting the wrong spark plug type can damage the engine Inspecting the safety system Main fuse Checking the tyre pressureChecking the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your handInstalling BioClip Removing the cutting unitChecking and adjusting the cutting unit’s ground pressure Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitBelt replacement on BioClip Replacing the cutting unit beltBelt change on Combi Maintenance Service position for the cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip 90, Combi Removal of BioClip plug CombiLubrication Checking the engine’s oil levelChanging the oil Changing the oil filterLubricating the belt adjuster Checking the transmission’s oil levelGeneral lubrication Trouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage CoverTechnical Data EU declaration of conformity Only applies to Europe Service Journal Pre-delivery serviceWork done Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01