Husqvarna 15V2 manual Checking the transmission’s oil level, Lubricating the belt adjuster

Page 43

LUBRICATION

Checking the transmission’s oil level

1.Remove the transmission cover. Loosen both screws (one on each side) and lift off the

transmission cover.

2.Check that there is oil in the transmission’s oil tank. Fill if necessary with engine oil SAE 10W/ 30 (class SF–CC).

Lubricating the belt adjuster

The belt adjuster should be lubricated regularly using good quality molybdenum disulphide grease*.

1 nipple from the right-hand side under the engine’s lower belt pulley, until grease is forced out.

With daily use lubrication should be conducted twice a week.

General lubrication

All joints and bearings are lubricated on manufacture with molybdenum sulphide grease. Re-grease with same type of grease*. Lubricate the steering and control wires with engine oil.

The machine should be lubricated regularly, and twice a week when used daily.

*Grease from well-known brand names (petrol companies, etc.) usually maintains a good quality. The most important property is that the grease provides good protection against corrosion.

English – 41

Image 43

Contents English RiderSvenska Contents Towing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceExplanation of Symbols General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Parking brake Throttle controlChoke lever Speed limiterLift lever for cutting unit Cutting unitSeat Lever for adjustment of cutting heightFuelling Before starting DrivingStarting the engine Driving Driving the machine Cutting tips Release lever Stopping the engineHours Before start 100 200 MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removing the machine hoodsEngine hood Front hoodAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Checking and adjusting the choke wire Checking and adjustment of the throttle wireReplacing the fuel filter Varning Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseChecking the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Installing BioClipChecking and adjusting the cutting unit’s ground pressure Replacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelismBelt change on Combi Maintenance Placing in service position Service position for the cutting unitMaintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, CombiChecking the engine’s oil level LubricationChanging the oil filter Changing the oilChecking the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data EU declaration of conformity Only applies to Europe Pre-delivery service Service JournalWork done Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01