Husqvarna 15V2 manual Removing the machine hoods, Engine hood, Front hood, Right-hand fender

Page 23

MAINTENANCE

Removing the machine hoods

Engine hood

The engine is accessible for servicing when the engine hood is lifted up.

Tilt the seat forward, release the rubber strap under the seat, and tilt the hood backwards.

Front hood

Release the clip on the front hood and lift off the hood.

Right-hand fender

Remove the knob (1), the screws (2 and 3) and lift off the fender.

3

2

11

Left-hand fender

Release the screws in the fender (2) and lift off the fender.

English – 21

Image 23

Contents English RiderSvenska Contents Towing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceExplanation of Symbols General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Parking brake Throttle controlChoke lever Speed limiterLift lever for cutting unit Cutting unitFuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting Driving Driving the machine Cutting tips Release lever Stopping the engineHours Before start 100 200 MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removing the machine hoodsEngine hood Front hoodPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacing the fuel filter Checking and adjustment of the throttle wireChecking and adjusting the choke wire Varning Replacing the air filterFitting the wrong spark plug type can damage the engine Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the engine’s cooling air intake Main fuseChecking the tyre pressure Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Installing BioClipChecking and adjusting the cutting unit’s ground pressure Replacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelismBelt change on Combi Maintenance Placing in service position Service position for the cutting unitMaintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, CombiChecking the engine’s oil level LubricationChanging the oil filter Changing the oilGeneral lubrication Lubricating the belt adjusterChecking the transmission’s oil level Problem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data EU declaration of conformity Only applies to Europe Work done Service JournalPre-delivery service Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01