Husqvarna 15V2 manual Installing BioClip, Removing the cutting unit

Page 31

MAINTENANCE

6.Move the support wheels to their parking position.

7.Fit the front cover.

8. Secure the collet spring.

Installing BioClip 90

In order to install BioClip 90 the drive belt support wheel must first be removed.

1.Release the collet spring, see fig above.

2.Remove the locking pin (1) that is located next to the support wheel.

3.Screw off the nut and washer (2) under the centre of the support wheel. Remove the screw and support wheel.

4.Fit the cutting unit according to the instructions above.

1

2

9

Removing the cutting unit

WARNING!

Wear protective glasses when removing the cutting unit. The collet spring which tensions up the belt can go off and cause personal injury.

1.Carry out points 1-9 to put the cutting unit in the service position, see “Service position for the cutting unit”.

2.Remove the bolt (3) and lift off the cutting unit.

2

1

3

English – 29

Image 31

Contents English RiderSvenska Contents Towing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceExplanation of Symbols General use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Parking brake Throttle controlChoke lever Speed limiterLift lever for cutting unit Cutting unitSeat Lever for adjustment of cutting heightFuelling Before starting DrivingStarting the engine Driving Driving the machine Cutting tips Release lever Stopping the engineHours Before start 100 200 MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removing the machine hoodsEngine hood Front hoodAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Checking and adjusting the choke wire Checking and adjustment of the throttle wireReplacing the fuel filter Varning Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseChecking the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Installing BioClipChecking and adjusting the cutting unit’s ground pressure Replacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelismBelt change on Combi Maintenance Placing in service position Service position for the cutting unitMaintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, CombiChecking the engine’s oil level LubricationChanging the oil filter Changing the oilChecking the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data EU declaration of conformity Only applies to Europe Pre-delivery service Service JournalWork done Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01