Chromalox 1604-7 user manual Para, ER0

DEFAULT CONFIGURATION PARAM- ETERS

The configuration parameters can be loaded with predetermined default values. These data are the typical values loaded in the instrument prior to shipment from factory. To load the default values proceed as follows:

a)The internal switch (V101, see fig. 13) should be open.

b)The upper display will show:

C O n F

c)Push the t pushbutton; the display will show the firmware version.

C O n F

A. 0 0

d)Maintaining the pressure on the t pushbutton push the s pushbutton also.

The instrument will show:

O F F

d F L t

e)Press s pushbutton to select between table 1 (European) or table 2 (American) default set of parameters; the display will show:

t b. 1

d F L t

f) Press FUNC pushbutton; the display will show:

L O A d

This means that the loading procedure has been initiated. After about 3 seconds the loading procedure is terminated and the instrument reverts to visualization as in point b).

PARA.	TABLE 1	TABLE 2
SEr 1	ErO	ER0
SEr 2	1	1
SEr 3	19200	19200
SEr 4	7E	7E
P1	3	21
P2	----.	----.
P3	0	0
P4	400	1000
P5	rEV	rEV
P6	0-20	0-20
P7	0	0
P8	400	1000
P9	nonE	nonE
P10	H.A.	H.A.
P11	nonE	nonE
P12	H.A.	H.A.
P13	OPrt.	OPrt
P14	0	0
P15	0.1	0.1
P16	0	0
P17	0	0
P18	norL	norL
P19	norL	norL
P20	norL	norL
P21	norL	norL
P22	Air	Air
P23	OFF	OFF
P24	rEV	rEV
P25	OFF	OFF
P26	rEV	rEV
P27	OFF	OFF
P28	0	0

Appendix A.2

1604-7-A-AB.p65 2 5/16/00, 10:50 AM