Black & Decker 598111-01 Grounding Instructions, Ground Fault Circuit Interrupter Protection

598111-01,PW1300 manual 1/31/05 1:51 PM Page 3

20.Pressure washer is not meant to pump hot water. Never connect it to a hot water supply as it will significantly reduce the life of the pump.

21.Never store the pressure washer outdoors or where it could freeze. The pump will be seriously damaged.

22.Discharge residual pressure by pressing the trigger until no more water comes out of the nozzle.

CAUTION: Wear appropriate hearing and respiratory protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.

WARNING: This product contains chemicals, including lead, known to the state of California to cause cancer, and birth defects or other reproductive harm.

Wash hands after handling.ash hands

GROUNDING INSTRUCTIONS

This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

DANGER: Improper connection of the equipment-grounding conductor can result in a risk of electrocution. Check with a qualified electrician or service personnel if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the product - if it will not fit the outlet, have a proper outlet installed by a qualified electrician. Do not use any type of adapter with this product.

WARNING: To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands.

GROUND FAULT CIRCUIT

INTERRUPTER PROTECTION

This pressure washer is provided with a Ground Fault Circuit Interrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electrical shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection. See Figure 7 for testing procedure.

WARNING: Connect directly to outlet. Do not use with extension cord. The use of an extension cord will override the GFCI built into the plug of the power supply cord resulting in the risk of electrical shock.

•The label on your tool may include the following symbols.

V			volts
A			amperes
Hz			hertz
W			watts
min			minutes
	............		alternating current
			direct current
		........
no			no load speed
	............		Class II Construction
…/min			revolutions or reciprocation
................			per minute
			earthing terminal
	............
	............		safety alert symbol

SAVE THESE INSTRUCTIONS

3