ASSEMBLY
ASSEMBLY
IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From Carton
•Remove the parts bag, accessories, and inserts included with pressure washer.
•Slice two corners at the end of carton from top to bottom so the panel can be folded down flat.
•Remove pressure washer from carton.
PREPARING PRESSURE WASHER FOR USE
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Attach handle to main unit.
2.Add oil to engine crankcase.
3.Add fuel to fuel tank.
4.Connect high pressure hose to spray gun and pump.
5.Connect water supply to pump.
6.Attach nozzle extension to spray gun.
Carton Contents
Items in the carton include:
•Main Unit Handle
•Goggles
•High Pressure Hose
•Spray Gun
•Adjustable Nozzle Extension
•Parts Bag (which includes the following):
•Hose Fittings
•Quick Connects
•Maintenance Kit
•Owner’s Manual
•Engine Manual
•Handle Fastening Hardware Kit (which includes):
•Carriage Bolts (2)
•Plastic Knobs (2)
•“L” Hooks (2)
•Plastic Knobs (2)
If parts are missing or damaged, contact the local Briggs & Stratton service center.
Attach Handle to Unit
1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 2).
Figure 2 — Attach Handle to Base
Handle
Align Holes 
Handle
Supports
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
2.Insert carriage bolts through holes from outside of the unit and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.
Figure 3 — Secure Handle
7