Zenoah BC2000 manual Operation Fonctionnement, OP4 OP5, Stopping Engine, Arret DU Moteur

Page 32

 

English

 

Français

 

 

7. Operation

7. Fonctionnement

 

 

 

 

 

OP4

(A) (B)

(C)1

2

OP5

4.While pulling the throttle lever (OP4,1,2), set the ignition switch to the “I (START)” position and release the throttle. Then the throttle lever is in to the “start position”. (OP4)

(A)stop

(B)start

(C)ignition switch

5.While holding the unit firmly, pull out the starter rope quickly until engine fires. (OP5)

IMPORTANT

•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

6.Move the choke lever downward to open the choke. And restart the engine. (OP3)

7.Allow the engine to warm up for a several minutes before starting operation.

NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

■STOPPING ENGINE

1.Release the throttle lever and run the engine for a half minute.

2.Shift the ignition switch to the “O (STOP)” position. (OP4)

4.Tout en ramenant la manette de commande des gaz vers vous, commutez l’interrupteur d’allumage en position “I (START)”, puis relâchez la manette.Puis positionnez la manette des gaz en “position de démarrage”. (OP4)

(A)Arrêt

(B)Marche

(C)Interrupteur d’allumage

5.Tout en maintenant fermement la machine, tirer la poignée de démarrage (OP5).

IMPORTANT

•Eviter de tirer à fond sur la corde de démarrage ou de relâcher brutalement la poignée. Ces opérations risquent d’endommager le système de démarrage.

6.Ramener le levier du starter vers le bas pour le remettre en position ouverte. Et redémarrer le moteur (OP3).

7.Laisser le moteur chauffer pendant plusieurs minutes avant de commencer à travailler.

REMARQUE

1.Pour redémarrer le moteur aussitôt après l’avoir arrêté, laisser le starter en position ouverte.

2.Trop tirer sur le starter risque de rendre le moteur difficile à démarrer à cause de l’excès de carburant. Si le moteur refuse de démarrer après plusieurs tentatives infructueuses, placer le starter en position ouverte et tirer à nouveau plusieurs fois la corde de démarrage ou enlever et sécher la bougie.

■ARRET DU MOTEUR

1.Relâcher la manette d’accélérateur et laisser tourner le moteur pendant encore 30 secondes.

2.Placer le bouton de contact sur “(Arrêt) O”. (OP4)

IMPORTANT

•Except for an emergency, avoid stopping the engine while pulling the throttle lever.

IMPORTANT

•Sauf en cas d’urgence, ne jamais couper le contact lorsqu’on accélére.

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents BC2000 English Français Deutsch Italiano Español Page Risk of Damaging Hearing Hörschaden RisikoRischio DI Danno Uditivo Riesgo DE Daño AuditivoContents Tables des matieres Inhalt Indice Contenido Parts location Emplacement des pieces Cabezal de línea BC2000 SpecificationsFiche technique Especificaciohes Technische DatenDati tecnici Symbols on the machine Symboles utilises sur la Machine EmplacementEtiquettes d’avertissement Machine Sur la machinePosizione Posición Position PosizioneFor safe operation Consignes de securite Working ConditionWorking Circumstance Conditions DE TravailArbeitsbedingung ArbeitsumstandCondizioni Lavorative Circostanze LavorativeWorking Plan Before Starting the EnginePlan DE Travail LA MachinePlan DE Trabajo ArbeitsplanPiano DI Lavoro Starting the Engine Demarrage DU MoteurAvvertimento Advertencia DEN Motor StartenAccensione DEL Motore Arranque DEL MotorUsing the Product MaintenanceIf Someone Comes Utilisation DE LA MachineBenutzung DES Produktes Falls Sich Jemand NähertWartung Utilizzo DEL ProdottoCheck ok Handling FuelRefill after cooling the engine Komatsu ZenoahManipulación DEL Combustible Handhabung DES KraftstoffsManeggio DEL Carburante Transportation TransportTransporte Motore si è raffreddatoTrasporto Comment Effectuer LE Melange DE Carburant ? HOW to MIX FuelFuel Carburant Kraftstoff Carburante Combustible Mischen VON KraftstoffPER IL Miscelazione DEL Carburante Cómo Mezclar EL CombustibleFuel Carburant Fueling the Unit Remplissage DU ReservoirFor Your Engine LIFE, Avoid Pour Prolonger LA Duree DE VIE DU MOTEUR, NE PAS UtiliserEinfüllen VON Kraftstoff DAS Gerät Riempimento DEL Serbatoio DEL CarburanteCómo Cargar Combustible EN LA Unidad Wegen DER Lebensdauer Ihres GERÄTES, Folgendes VermeidenOperation Fonctionnement OP1OP2 OP3Betrieb Funzionamento Uso Operation Fonctionnement OP4 OP5Stopping Engine Arret DU MoteurCómo Parar EL Motor Stoppen DES MotorsArresto DEL Motore OP6 OP7Einstellen DES Leerlaufs Regolazione Della Velocità NEL Funzionamento AL Minimo OP6Ajuste DE LA Velocidad DE Marcha EN Vacío OP6 Gras UND Unkraut SchneidenAdjusting the Line Length Reglage DE LA Longeur DU FIL DE CoupeAjuste DE LA Longitud DE LA Línea Einstellung DER SchnurlängeRegolazione Della Lunghezza Della Corda Maintenance Chart MaintenaceEntretien Tableau D’ENTRETIENMantenimiento WartungManutenzione Refilling Trimming Line Remplacement DU FIL DE Coupe Maintenace EntretienMA1 MA2 MA3 MA4 MA5Wartung Manutenzione Mantenimiento MA8 Maintenace EntretienMA6 MA7 Wartung Manutenzione Mantenimiento Procedures to be Performed After Every 100 Hours of USE Procedure a Effectuer Toutes LES 100 Heures D’UTILISATIONIntake AIR Cooling Vent Ouïe DU Refroidissement PAR AIRProcedure DA Effettuare Ogni 100 ORE DI Utilizzo ANSAUGLUFT-KÜHLSCHLITZESfiato DI Raffreddamento DELL’ARIA DI Aspirazione Toma DE Aire DE RefrigeraciónStorage Rangement Lagerung Immagazzinaggio Almacenamiento NachziehenTroubleshooting guide Guide de localisation des pannesCheck Probable Causes Action Verification Causes Probables ActionLocalizzazione dei guasti 10. Guía de localización y solución de problemasFehlersuche Limited warranty Garantie limitée Garantiebestimmungen Garanzia limitata Garantía limitada

BC2000 specifications

The Zenoah BC2000 is a cutting-edge brushcutter designed for both commercial and residential users who seek efficiency, durability, and ease of use in their gardening equipment. With a robust 20cc engine, it delivers powerful performance capable of tackling tough vegetation and overgrown areas with ease. One of the standout features of the BC2000 is its lightweight design, which is essential for extended use without causing excessive fatigue to the operator. Weighing in at just approximately 5.5 kg, the machine strikes a perfect balance between portability and power.

The BC2000 employs a high-capacity string trimmer head that can accommodate various cutting attachments, making it versatile for different landscaping tasks. This feature allows users to switch between trimming and cutting tasks seamlessly, enhancing productivity in the field. The dual-line cutting system is designed to deliver efficient cutting, ensuring that even thicker grass and brush can be managed effectively.

Zenoah has integrated advanced anti-vibration technology in the BC2000, significantly reducing the fatigue experienced during prolonged operation. This technology helps isolate motor vibrations from the handle, ensuring a smoother experience for the operator. Additionally, the ergonomic design of the handle provides improved comfort and control, allowing for precision in cutting without compromising the user's grip.

Another key characteristic of the Zenoah BC2000 is its easy-start engine system. Designed for user-friendliness, this feature minimizes the effort required to start the machine, saving valuable time and energy, particularly in situations where quick readiness is essential. The fuel efficiency of the BC2000 is noteworthy as well, providing extended run times on a single tank, which is advantageous for larger tasks or jobs that require sustained operation.

Additionally, the BC2000 is built with durability in mind, using high-quality materials that withstand the rigorous demands of outdoor use. Its rugged design makes it resistant to wear and tear, making it an ideal investment for both professionals and hobbyists.

In conclusion, the Zenoah BC2000 stands out as a versatile, powerful, and user-friendly brushcutter. Its combination of lightweight construction, advanced technology, and ergonomic design serves the needs of diverse users, making it a reliable choice for maintaining landscapes and gardens effectively. Whether for commercial landscaping or home gardening, the BC2000 is a tool that promises high performance and ease of use.
Top Page Image Contents