Subaru Robin Power Products RGV6100, RGV4100 service manual Range of Applications

Page 26

7. RANGE OF APPLICATIONS

Generally, the power rating of an electrical appliance indicates the amount of work that can be done by it. The electric power required for operating an electrical appliance is not always equal to the output watt- age of the appliance. The electrical appliances generally have a label showing their rated voltage, fre- quency, and power consumption (input wattage). The power consumption of an electrical appliance is the power necessary for using it. When using a generator for operating an electrical appliance, the power factor and starting wattage must be taken into consideration.

In order to determine the right size generator, it is necessary to add the total wattage of all appliances to be connected to the unit.

Refer to the followings to calculate the power consumption of each appliance or equipment by its type.

(1)Incandescent lamp, heater, etc. with a power factor of 1.0

Total power consumption must be equal to or less than the rated output of the generator. Example : A rated 3000W generator can turn thirty 100W incandescent lamps on.

(2)Fluorescent lamps, motor driven tools, light electrical appliances, etc. with a smaller power factor

Select a generator with a rated output equivalent to 1.2 to 2 times of the power consumption of the load. Generally the starting wattage of motor driven tools and light electrical appliances are 1.2 to 3 times lager than their running wattage.

Example : A rated 250 W electric drill requires a 400 W generator to start it.

NOTE1 : If a power factor correction capacitor is not applied to the fluorescent lamp, the more power shall be required to drive the lamps.

NOTE2 : Nominal wattage of the fluorscent lamp generally indicates the output wattage of the lamp. Therefore, if the fluorescent lamp has no special indication as to the power consumption, effi- ciency should be taken into account as explained in ltem (5) on the following page.

(3)Mercury lamps with a smaller power factor

Loads for mercury lamps require 2 to 3 times the indicated wattage during start-up.

Example : A 400 W mercury lamp requires 800 W to 1200 W power source to be turned on. A rated 3000 W generator can power two or three 400 W mercury lamps.

(4)Initially loaded motor driven appliances such as water pumps, compressors, etc. These appliances require large starting wattage which is 3 to 5 times of running wattage. Example : A rated 900 W compressor requires a 4500 W generator to drive it.

NOTE1 : Motor-driven appliances require the aforementioned generator output only at the starting. Once their motors are started, the appliances consume about 1.2 to 2 times their rated power con- sumption so that the excess power generated by the generator can be used for other electrical appliances.

NOTE2 : Motor-driven appliances mentioned in items (3) and (4) vary in their required motor starting power depending on the kind of motor and start-up load. If it is difficult to determine the optimum generator capacity, select a generator with a larger capacity.

- 23 -

Page 25 Page 27
Image 26
Page 25 Page 27
Contents RGV2800, RGV4100, RGV6100 Generators Contents Wiring Diagram Disassembly and AssemblyTroubleshooting Specifcations Generator Trouble ShootingModel SpecificationsEngine RGV2800 RGV4100RGV6100 EH34DPerfomance Curves 250 125 240 120 230 115 220 110 230V/115V Load RatedDC Output Features Minimal Maintenance LONG-LIFE DurabilityOIL Drain Plug General DescriptionExternal View RGV4100 U.S.A., 60Hz-120V/240V Nema Receptacle Control PanelRGV2800 U.S.A., 60Hz-120V Nema Receptacle Location of Serial Number and Specification Number RGV6100 U.S.A., 60Hz-120V/240V Nema ReceptacleFunction Construction and FunctionConstruction StatorCondenser RotorObject or Protection NO-FUSE BreakerDC Circuit Breaker RGV2800Style Ampere AC plug DescriptionConnecting to Domestic Circuits House Wiring 240V appliance Voltage Fluctuations Under Load Generator OperationGeneration of NO-LOAD Voltage Position Full Power Switch Dual Voltage TypeSwitch 120/240 Half of rated output Rated outputPage Principle of Sensing OIL Level Power supplyDescription HOW IT OperatesDecision of oil shortage Block Diagram of the CircuitJudgement of oil level Automatic stop of enginePage Do not place inflammable materials near the generator Safety PrecautionsDo not connect the generator to the commercial power lines Operate the generator on a level surfaceRange of Applications Incandescent lamp, heater, etc. with a power factorMercury lamps with a smaller power factor Appliances without any indication as to power consumption RGV2800 RGV4100 RGV610010 a 12 a 15 a Sectional Allowable Gauge No ResistanceArea / mm3 Current / a Measuring Instruments Measuring ProceduresSpecifications 1 Dr. Robin Generator TesterInstruments VoltmeterCircuit Tester Rated voltage 120 240 AC Output MeasuringDC Output Measuring Rotor Measuring Insulation ResistanceStator Control Panel AC Receptacles Checking Functional MembersVoltmeter Specification AC Winding Condenser Winding75 Ω 77 Ω 60 Ω Rotor AssemblyCondenser Apply red plus needle Brown Diode RectifierChecking table for analogue circuit tester Circuit tester OrangeCircuit tester Checking table for digital circuit testerApply black minus needle Brown Brown / WhiteDisassembly and Assembly Preparation and PrecautionsDisassembly Procedures Step Part to remove Description Remarks ToolRubber Pipe Hose Clamp Step Part to remove Description Remarks Tool M8 flange nut pcs Rear Cover Stator Cover Rear Cover Brushing Spring Seal Tape Part to remove Description Remarks Tool Tightening torque 11.8 13.7 N-m Assembly ProceduresFront Cover Tightening torque 11.3 13.2 N-m RGV2800Rear Cover Tightening torque 5.9 N-mEND Cover RGV4100 only FrameTightening torque 18.6 24.5 N-m Tightening torque 9.8 N-mTightening torque 21.6 27.4 N-m Tightening torque 6.9 N-m Checking of the Front Panel DisassemblyFront Panel Reassembly Tightening torque 1.5 N-mChecking Condenser TroubleshootingNo AC Output Checking StatorChecking Rotor RemedyChecking Engine Speed How to adjust engine r.p.mAC Voltage is TOO High or TOO LOW Checking RotorCheck if the Engine is Overheated Check the Engine SpeedCheck the Appliance for Trouble Check the Insulation of the GeneratorNo DC Output Check the DC Coil Engine Speed is not Increased When a Load is AppliedIdle Control Apply red plus needle Single Voltage TypeDual Voltage Type Engine Speed is not Reduced When Load is OFF Normal ResistanceRGV4100 U.S.A., 60Hz-120V/240V Type Nema Receptacle Wiring DiagramRGV2800 U.S.A., 60Hz-120V Type Nema Receptacle RGV6100 U.S.A., 50Hz-120V/240V Type Nema Receptacle GeneratorWiring color cord RGV4100, 6100 Electric Starter TypeRGV4101RGV6101 OdelMRGV4101 Generator TroubleshootingRGV4101 RGV6101 85 Ω RGV4101 RGV6101 Check the Engine Speed No DC Output Checking table for analogue circuit tester Idle Control Optional Equipment Idelcontrolunit Output Wire ZCT TheIDELCONTROLUNIT Range of Applications Appliances without any indication as to power consumption Sectional Allowable Gauge No Resistance RGV4101 RGV4101 Electric starter modelRGV6101 RGV6101 Electric starter modelLively Blvd. Wood Dale, IL 60191 Phone 630-350-8200 Fax
Top Page Image Contents