Subaru Robin Power Products 13100T 5 A.V.R Automatic Voltage Regulator RGV12100 only, - 8-

Page 11

4-2-5 A.V.R

(AUTOMATIC VOLTAGE REGULATOR) (RGV12100 only)

The automatic voltage regulator employs an electronic circuit to automatically regulate voltage.

4-2-6 ECU (ELECTRONIC CONTROL UNIT)

ECU controls the start/stop of an engine enabling the fuel cut while stop.

It also automatically stops the engine if an abnormal oil pressure occurs.

Function

Description of Operation

 

 

 

When the lubrication oil pressure drops below the safety limit (Oil pressure

 

becomes less than 1kg/cm2) and/or the engine speed ups above the safety

Warning lamp

limit (Engine speed increases higher than 4,500 r/min for 7 seconds), the

 

warning lamp repeats turning on and off, and the engine stops automati-

 

cally. The warning lamp turns off after 3 minutes.

 

 

 

When the engine started and reaches 1,050 r/min, the starter motor is

 

automatically stopped.

Starter motor control

 

When the engine is operating, the starter motor can not start.

 

 

 

8

Image 11
Contents Generators Contents - 04- - 1- Specifications- 2- Performance Curves- 3- General Description of Generator- 4- Control Panel- 5- Serial Number- 6- Construction and FunctionStator Diode Unit RGV13100T only RotorBrush / Brush Holder Current Transformer- 8- 5 A.V.R Automatic Voltage Regulator RGV12100 onlyECU Electronic Control Unit - 9- Idle Control Unit RGV12100 only- 10- OIL Pressure SwitchAC Switch NO-FUSE Breaker Relief Valve- 11- AC ReceptacleRGV13100T AC plug Description - 12-- 13- Connecting to Domestic Circuit House WiringGfci Receptacle - 14- - 15- - 16- AC Three Phase Receptacle RGV13100T only- 17- Description of Generator OperationPrimary Exciting Action RGV12100 Voltage Regulating Mechanism RGV12100- 18- Current Transformer Control RGV13100TAdvantages of Current Transformer Control RGV13100T Do not operate with wet hands or in the rain Safety PrecautionsDo not place inflammable materials near the generator Operate the generator on a level surface- 20- Incandescent lamp, heater, etc. with a power factorRange of Applications Motor driven tools and light electrical appliances- 21- Appliances without any indication as to power consumption- 22- - 23- Measuring ProceduresMeasuring Instruments - 24- AC Output Measuring- 25- Measuring Insulation ResistanceStator - 26- RotorControl Panel Current Transformer RGV13100T- 27- Checking Functional MembersPilot Lamp and Voltmeter AC Receptacles- 28- RGV12100- 29- Rotor AssemblyExciting Coil RGV12100 only - 30- BrushA.V.R Automatic Voltage Regulator- 31- Current Transformer RGV13100T only- 32- Idle Control UnitRGV12100 only - 33- Alternator Disassembly and AssemblyPreparation and Precautions Disassembly Procedures Control Panel- 35- Component PartsGenerator assembly Control Box RGV12100 Control Box RGV13100T Fuel Tank - 40- Generator Assembling Procedures Front Cover- 41- - 42- Rear Cover- 43- Check if engine is overheated TroubleshootingNo AC output AC Voltage is too high or too low Check engine speed- 45- Engine dose not run- 46- Wiring Diagram- 47- Lively Blvd. Wood Dale, IL 60191 Phone 630-350-8200 Fax