Subaru Robin Power Products RGV12100, 13100T service manual Component Parts, － 35－

Page 38

(7) Remove the stator. (See Fig. 9-3)

NOTE : The stator is heavy. Be careful do not hit the coil of the stator to the rotor.

(8)Loosen the through bolt of the rotor.

(9)Remove the rotor with the soft hammer. (See Fig. 9-4)

NOTE : Temporarily tighten the through bolt of the rotor when hit the rotor. (See Fig. 9-4)

(10) Remove the front cover.

	Fig. 9-3
THROUGH	ROTOR
THROUGH
BOLT
	SOFT
	HAMMER
	Fig. 9-4

9-3 COMPONENT PARTS

For disassembling and assembling, the following illustrations show the major component parts and their configuration for (1) Generator assembly, (2) Control Box and (3) Fuel Tank and sys- tem.

The specified tightening torque is indicated in the illustration.

－ 35－

Image 38

Contents Generators Contents － 04－ Specifications － 1－Performance Curves － 2－General Description of Generator － 3－Control Panel － 4－Serial Number － 5－－ 6－ Construction and FunctionStator Current Transformer RotorBrush / Brush Holder Diode Unit RGV13100T only－ 8－ 5 A.V.R Automatic Voltage Regulator RGV12100 onlyECU Electronic Control Unit Idle Control Unit RGV12100 only － 9－Relief Valve OIL Pressure SwitchAC Switch NO-FUSE Breaker － 10－－ 11－ AC ReceptacleRGV13100T － 12－ AC plug Description－ 13－ Connecting to Domestic Circuit House WiringGfci Receptacle － 14－－ 15－ AC Three Phase Receptacle RGV13100T only － 16－Voltage Regulating Mechanism RGV12100 Description of Generator OperationPrimary Exciting Action RGV12100 － 17－－ 18－ Current Transformer Control RGV13100TAdvantages of Current Transformer Control RGV13100T Operate the generator on a level surface Safety PrecautionsDo not place inflammable materials near the generator Do not operate with wet hands or in the rainMotor driven tools and light electrical appliances Incandescent lamp, heater, etc. with a power factorRange of Applications － 20－Appliances without any indication as to power consumption － 21－－ 22－－ 23－ Measuring ProceduresMeasuring Instruments AC Output Measuring － 24－－ 25－ Measuring Insulation ResistanceStator Current Transformer RGV13100T RotorControl Panel － 26－AC Receptacles Checking Functional MembersPilot Lamp and Voltmeter － 27－RGV12100 － 28－－ 29－ Rotor AssemblyExciting Coil RGV12100 only Automatic Voltage Regulator BrushA.V.R － 30－Current Transformer RGV13100T only － 31－－ 32－ Idle Control UnitRGV12100 only － 33－ Disassembly Procedures Control Panel Disassembly and AssemblyPreparation and Precautions AlternatorComponent Parts － 35－Generator assembly Control Box RGV12100 Control Box RGV13100T Fuel Tank Generator Assembling Procedures Front Cover － 40－－ 41－ Rear Cover － 42－－ 43－ AC Voltage is too high or too low Check engine speed TroubleshootingNo AC output Check if engine is overheatedEngine dose not run － 45－Wiring Diagram － 46－－ 47－ Lively Blvd. Wood Dale, IL 60191 Phone 630-350-8200 Fax