Subaru Robin Power Products 13100T service manual Idle Control Unit RGV12100 only, - 9-

Page 12

Function

Description of Operation

 

 

 

When the key switch or the remote control switch is turned to "START", the

 

fuel cut-off valve of the carburetor opens. When the key switch or the

 

remote control switch is turned to "STOP", the fuel cut-off valve closes.

 

 

 

If the starter motor is locked by any reason, the starter motor is shut off

 

automatically after 3 seconds.

 

 

Fail-safe function

When the engine dose not start (engine speed does not reach 1,050

r/min), the starter motor is stopped after 21 seconds.

 

 

 

 

When the remote controller is connected, the electric starter dose not run

 

when the switch of remote controller is turned "OFF" even if the key switch

 

on the generator is turned to "START".

 

 

 

When the engine speed increases higher than 4,500 r/min for 7 seconds,

 

the engine is shut down automatically and the warning lamp repeats turn-

 

ing on and off for 3 minutes.

 

 

Self checking function for

When the key switch or remote control switch is turned to "START", the

warning lamp lights up for a moment to indicate that the bulb for the warn-

warning lamp bulb

ing lamp is normal.

 

 

 

4-2-7 IDLE CONTROL UNIT (RGV12100 only)

The idle control unit 1 releases throttle valve when the applied load current exceeds 0.04A.

The two output wires 2 from the main coils must go through the ZCT 3 in the same direction.

NOTE :

It is normal that the engine speed goes up for a moment when you turn the key switch to "STOP" while the Idle Control Switch is in "ON" position.

1

3

2

9

Image 12
Contents Generators Contents - 04- Specifications - 1-Performance Curves - 2-General Description of Generator - 3-Control Panel - 4-Serial Number - 5-Construction and Function Stator- 6- Rotor Brush / Brush HolderCurrent Transformer Diode Unit RGV13100T only5 A.V.R Automatic Voltage Regulator RGV12100 only ECU Electronic Control Unit- 8- Idle Control Unit RGV12100 only - 9-OIL Pressure Switch AC Switch NO-FUSE BreakerRelief Valve - 10-AC Receptacle RGV13100T- 11- - 12- AC plug DescriptionConnecting to Domestic Circuit House Wiring Gfci Receptacle- 13- - 14- - 15- AC Three Phase Receptacle RGV13100T only - 16-Description of Generator Operation Primary Exciting Action RGV12100Voltage Regulating Mechanism RGV12100 - 17-Current Transformer Control RGV13100T Advantages of Current Transformer Control RGV13100T- 18- Safety Precautions Do not place inflammable materials near the generatorOperate the generator on a level surface Do not operate with wet hands or in the rainIncandescent lamp, heater, etc. with a power factor Range of ApplicationsMotor driven tools and light electrical appliances - 20-Appliances without any indication as to power consumption - 21-- 22- Measuring Procedures Measuring Instruments- 23- AC Output Measuring - 24-Measuring Insulation Resistance Stator- 25- Rotor Control PanelCurrent Transformer RGV13100T - 26-Checking Functional Members Pilot Lamp and VoltmeterAC Receptacles - 27-RGV12100 - 28-Rotor Assembly Exciting Coil RGV12100 only- 29- Brush A.V.RAutomatic Voltage Regulator - 30-Current Transformer RGV13100T only - 31-Idle Control Unit RGV12100 only- 32- - 33- Disassembly and Assembly Preparation and PrecautionsDisassembly Procedures Control Panel AlternatorComponent Parts - 35-Generator assembly Control Box RGV12100 Control Box RGV13100T Fuel Tank Generator Assembling Procedures Front Cover - 40-- 41- Rear Cover - 42-- 43- Troubleshooting No AC outputAC Voltage is too high or too low Check engine speed Check if engine is overheatedEngine dose not run - 45-Wiring Diagram - 46-- 47- Lively Blvd. Wood Dale, IL 60191 Phone 630-350-8200 Fax