Intel IQ80321 manual Using Breakpoints

Intel® IQ80321 I/O Processor Evaluation Platform

Getting Started and Debugger

B.7.4 Using Breakpoints

Note the small gray circles on the sidebar beside each line of source code. Single-click any of these gray circles and a red dot appears. The red dot represents a break point. Single-click the red dot to remove it, or click the “Remove all breakpoints” icon.

Place a breakpoint on the following lines of code in “blink.c”:

displayLED(leds[8],leds[0]);	/* LED display '80'	*/
displayLED(leds[0],leds[3]);	/* LED display '03'	*/
displayLED(leds[3],leds[2]);	/* LED Display '32'	*/
displayLED(leds[2],leds[1]);	/* LED display '21'	*/
displayLED(leds[16],leds[16]);	/* LED display ' '	*/

1.Click the “Go” icon.

The yellow arrow stops at the first break point and the HEX display does not change.

2.Click the “Go” icon again.

The last instruction has now been executed and an “80” is displayed.

3.Continue on in this fashion, watching the lines execute only as they are called, while the yellow arrow shows exactly what line is up next in execution.

4.Click the “Remove all breakpoints” icon .

5.Press “Go” again and notice that the program loop is infinite.

6.Press the “Halt” icon to stop execution.

7.Close the debugger and cycle power to the board.

98 Board Manual