Konica Minolta NC-6 user manual Checking the Setup Procedures, Peer-to-Peer Printing

Getting Ready

2

2.2Checking the Setup Procedures

This section describes the required procedures for setting up network printing for the selected network print method.

Peer-to-Peer Printing

1Check that all of the accessories have been included in the package. (“3 Checking the Accessories”)

2Connect the network cable. (“4 Connecting the Network Cable”)

3Specify the IP address, subnet mask, and default gateway settings for the copier. (“5 Assigning an IP Address”)

4Print the Configuration Page and check the settings. (“6 Printing the Configuration Page”)

Note

The Configuration Page cannot be printed for copiers that are not equipped with the optional PCL printer controller or fax option.

5Install the printer driver. The Peer-to-Peer Utility is installed when you install the printer driver.

❍For instructions on installing the GDI driver, refer to “GDI Printer Controller” in the manual provided with the copier. For instructions on installing the optional PCL driver, refer to “PCL Printer Controller” in the manual provided with the PCL printer controller.

6Add a network port to the computer. (“7 Connecting the Computer and Copier”)

NC-6 2-7