Lenovo 6445, 6447, 6446, 6444 manual Battery return program, For the European Union

Page 102
Battery return program

L’etiquette du système respecte la Directive européenne 2002/96/EC en matière de Déchets des Equipements Electriques et Electroniques (DEEE), qui détermine les dispositions de retour et de recyclage applicables aux systèmes utilisés à travers l’Union européenne. Conformément à la directive, ladite étiquette précise que le produit sur lequel elle est apposée ne doit pas être jeté mais être récupéré en fin de vie.

In accordance with the European WEEE Directive, electrical and electronic equipment (EEE) is to be collected separately and to be reused, recycled, or recovered at end of life. Users of EEE with the WEEE marking per Annex IV of the WEEE Directive, as shown above, must not dispose of end of life EEE as unsorted municipal waste, but use the collection framework available to customers for the return, recycling, and recovery of WEEE. Customer participation is important to minimize any potential effects of EEE on the environment and human health due to the potential presence of hazardous substances in EEE. For proper collection and treatment, contact your local Lenovo representative.

Battery return program

This product may contain a lithium or lithium ion battery. Consult your user manual or service manual for specific battery information. The battery must be recycled or disposed of properly. Recycling facilities may not be available in your area. For information on disposal or batteries outside the United States, go to http://www.lenovo.com/lenovo/environment or contact your local waste disposal facility.

For Taiwan: Please recycle batteries.

For the European Union:

Notice: This mark applies only to countries within the European Union (EU).

Batteries or packaging for batteries are labeled in accordance with European Directive 2006/66/EC concerning batteries and accumulators and waste batteries and accumulators. The Directive determines the framework for the return and recycling of used batteries and accumulators as applicable throughout the European Union. This label is applied to various batteries to indicate that the battery is not to be thrown away, but rather reclaimed upon end of life per this Directive.

Les batteries ou emballages pour batteries sont étiquetés conformément aux directives européennes 2006/66/EC, norme relative aux batteries et accumulateurs en usage et aux batteries et accumulateurs usés. Les directives déterminent la marche à suivre en vigueue dans l'UnionEuropéenne pour le retour et le recyclage des batteries et accumulateurs usés. Cette étiquette est appliquée sur diverses batteries pour indiquer que la batterie ne doit pas être mise au rebut mais plutôt récupérée en fin de cycle de vie selon cette norme.

88ThinkServer RD120 Types 6444, 6445, 6446, and 6447: Installation Guide

Image 102
Contents Installation Guide ThinkServer RD120 Types 6444, 6445, 6446, andPage Installation Guide First Edition October Copyright Lenovo Contents Chapter 3. Server controls, LEDs, and powerChapter 4. Configuring the server Appendix A. Getting help and technical assistance Safety Each caution and danger statement in this document is labeled with a number. This number is used to cross reference an English-language caution or danger statement with translated versions of the caution or danger statement in the Safety Information document Statement DANGER Statement Class 1 Laser Product Laser Klasse Laser Klass Luokan 1 Laserlaite ` Appareil A Laser de Classe≥ 18 kg 39.7 lb ≥ 32 kg 70.5 lb≥ 55 kg 121.2 lb Statement This server is suitable for use on an IT power-distribution system whose maximum phase-to-phase voltage is 240 V under any distribution fault condition Chapter 1. Introduction Hardware and software requirements The Lenovo ThinkServer Documentation DVDFeatures and specifications Notices and statements in this documentTable 1. Features and specifications MicroprocessorMajor components of the server Power backplane Chapter 2. Installing optional devices Installation guidelinesWorking inside the server with the power on System reliability guidelinesHandling static-sensitive devices Removing the coverInstalling a memory module DIMM connectors Pair1 1 and 2 7 and 3 2 and 4 8 and 5 3 and 6 9 and Page Memory mirroring Online-spare memory 1 1, 4, 7, and 2 2, 5, 8, and 3 3, 6, 9, andIn the configuration that you use, install the largest DIMMs first Table 5. Online-spare DIMM configurations, basic schemeInstalling a hard disk drive 3.5-inch drivesInstalling a tape drive 2.5-inch drivesInstalling an additional microprocessor connector Voltage regulator moduleMicroprocessor socket dust cover 4. Remove the microprocessor air baffle Note The microprocessor fits only one way on the socket 8. Install a heat sink on the microprocessor Installing an adapter Low-profile PCI Express adapterPCI riser card Access holes Release tabsHard disk drive cable connector 0 Installing a Remote Supervisor Adapter II SlimLineHard disk drive cable connector 4 Battery3. Remove the cover 4. Remove the PCI riser-card assembly Replacing the ServeRAID SAS controller Completing the installation Installing the cover Connecting the cablesFront view Updating the server configuration Rear viewIf you have installed or removed a hard disk drive, see “Usingthe RAID configuration programs” on page 44 for information about reconfiguring the disk arrays Page Chapter 3. Server controls, LEDs, and power Front viewPower-control button Power-on LEDSystem-error LED Hard disk drive activity LEDRear view Chapter 3. Server controls, LEDs, and powerServer power features Turning on the server Turning off the serverPage Chapter 4. Configuring the server Using the ThinkServer EasyStartup programUser Guide on the ThinkServer Documentation DVD Page Using ThinkServer EasyManage products Using the Configuration/Setup Utility programConfiguring the Gigabit Ethernet controllers Using the RAID configuration programs Using the IBM ServeRAID Configuration Utility programIBM ServeRAID Configuration Utility menu choices Using ServeRAID ManagerStarting the IBM ServeRAID Configuration Utility program Configuring the RAID controllerViewing the configuration 2. Click Express configuration2. Click Custom configuration Using the baseboard management controller BIOS update and configurationLinux configuration Red Hat Enterprise Linux ES 4 configurationLILO configuration If you are using LILO, complete the following steps Original /etc/lilo.conf contents 2. Run the lilo command to store and activate the LILO configuration Original /boot/grub/grub.conf contents SUSE SLES 9.0 configuration Modified /boot/grub/grub.conf contentsb. Add the following line before the first title line Original /boot/grub/menu.lst contentsModified /boot/grub/menu.lst contents c. Append the following text to the first title lineMicrosoft Windows 2003 Standard Edition configuration COM1 and that redirectbaudrate is set toInstalling the OSA SMBridge management utility program 3. Follow the prompts to complete the installation 3. Type mount/mnt/cdromUsing the baseboard management controller utility programs Page Page POST beep codes Chapter 5. Solving problemsDiagnostic tools overview v Diagnostics DVDOther beep codes POST POST error codesproblem found Failing device orTable 8. ThinkServer EasyStartup DVD EasyStartup problemsSymptom ActionTroubleshooting tables CD-RW/DVD drive problemsGeneral problems Hard disk drive problemsIntermittent problems the Hardware Maintenance ManualUSB keyboard, mouse, or pointing-device problems Memory problems Hardware Maintenance ManualMicroprocessor problems LEDs” in the Hardware Maintenance ManualMonitor problems Page Optional-device problems Power problemsSymptom Serial port problems Software problems Universal Serial Bus USB port problems Video problemsLight path diagnostics Diagnosing problems using light path diagnostics Light path diagnostics LEDsthe User Guide on the ThinkServer Documentation DVD for Description Using the documentation Appendix A. Getting help and technical assistanceBefore you call Calling for service Getting help and information from the World Wide WebLenovo product service Using other servicesPurchasing additional services Appendix A. Getting help and technical assistancePage Appendix B. Notices Lenovo United States, Inc 1009 Think Place - Building OneMorrisville, NC U.S.A Attention Lenovo Director of Licensing Trademarks Important notesWaste electrical and electronic equipment WEEE notices Appendix B. NoticesBattery return program For the European UnionFederal Communications Commission FCC statement German Ordinance for Work gloss statementElectronic emissions notices For CaliforniaAvis de conformité à la réglementation dIndustrie Canada United Kingdom telecommunications safety requirementIndustry Canada Class A emission compliance statement Australia and New Zealand Class A statementBetriebsmittein Japanese Voluntary Control Council for Interference VCCI statementDeutschland Das Gerät erfüllt die Schutzanforderungen nach EN 55024 und ENTaiwanese Class A warning statement Chinese Class A warning statement Korean Class A warning statementIndex A See SAS software problems connectorsIndex Page Page Part Number 46U0862 Printed in USA 1P P/N 46U0862