Lenovo 6447, 6446, 6445, 6444 manual Installing an additional microprocessor

Page 32
Installing an additional microprocessor

Installing an additional microprocessor

The following notes describe the type of microprocessor that the server supports and other information that you must consider when installing a microprocessor:

vThe server supports certain Intel Xeon dual-core or quad-core flip-chip land grid array 771 (FC-LGA 771) microprocessors, which are designed for the LGA771 socket. See http://www.lenovo.com/accessories for a list of supported microprocessors.

Important: Dual-core and quad-core microprocessors are not interchangeable and cannot be used in the same server. For example, if the server has a dual-core microprocessor, you cannot install a quad-core microprocessor as the second microprocessor. Use the Configuration/Setup Utility program to determine the type and speed of the microprocessor that is currently installed in the server.

vThe server supports up to two microprocessors. If the server comes with one microprocessor, you can install a second microprocessor.

vBoth microprocessors must have the same cache size and type, front-side bus frequency, and the same clock speed. Microprocessor internal and external clock frequencies must be identical.

vWhen you install an additional microprocessor in microprocessor connector 2, you must also install the voltage regulator module (VRM), which comes with the microprocessor, in the VRM connector.

vRead the documentation that comes with the microprocessor to determine whether you must update the basic input/output system (BIOS) code for the server. To download the most current level of BIOS code and many other code updates for your server:

1.Go to: http://www.lenovo.com/support.

2.Enter your product number (machine type and model number) or select Servers from the Select your product list.

3.Select Servers from the Brand list.

4.From Family list, select ThinkServer RD120, and click Continue.

5.Click Downloads and drivers to download firmware updates.

v(Optional) Obtain an SMP-capable operating system. For a list of supported operating systems and optional devices, go to http://www.lenovo.com/support/.

vTo order additional microprocessors, contact your Lenovo marketing representative or authorized reseller.

vThe microprocessor speeds are automatically set for this server; therefore, you do not have to set any microprocessor frequency-selection jumpers or switches.

vIf you have to replace a microprocessor, call for service.

vIf the thermal-grease protective cover (for example, a plastic cap or tape liner) is removed from the heat sink, do not touch the thermal grease on the bottom of the heat sink or set down the heat sink.

vDo not remove the first microprocessor from the system board to install the second microprocessor.

The following illustration shows the microprocessor connector locations and other microprocessor-related components on the system board.

18ThinkServer RD120 Types 6444, 6445, 6446, and 6447: Installation Guide

Image 32
Contents Installation Guide ThinkServer RD120 Types 6444, 6445, 6446, andPage Installation Guide First Edition October Copyright Lenovo Chapter 4. Configuring the server ContentsChapter 3. Server controls, LEDs, and power Appendix A. Getting help and technical assistance Safety Each caution and danger statement in this document is labeled with a number. This number is used to cross reference an English-language caution or danger statement with translated versions of the caution or danger statement in the Safety Information document Statement DANGER Statement Class 1 Laser Product Laser Klasse Laser Klass Luokan 1 Laserlaite ` Appareil A Laser de Classe≥ 55 kg 121.2 lb ≥ 18 kg 39.7 lb≥ 32 kg 70.5 lb Statement This server is suitable for use on an IT power-distribution system whose maximum phase-to-phase voltage is 240 V under any distribution fault condition Chapter 1. Introduction Hardware and software requirements The Lenovo ThinkServer Documentation DVDFeatures and specifications Notices and statements in this documentTable 1. Features and specifications MicroprocessorMajor components of the server Power backplane Chapter 2. Installing optional devices Installation guidelinesWorking inside the server with the power on System reliability guidelinesHandling static-sensitive devices Removing the coverInstalling a memory module 1 1 and 2 7 and 3 2 and 4 8 and 5 3 and 6 9 and DIMM connectorsPair Page Memory mirroring Online-spare memory 1 1, 4, 7, and 2 2, 5, 8, and 3 3, 6, 9, andIn the configuration that you use, install the largest DIMMs first Table 5. Online-spare DIMM configurations, basic schemeInstalling a hard disk drive 3.5-inch drivesInstalling a tape drive 2.5-inch drivesInstalling an additional microprocessor connector Voltage regulator moduleMicroprocessor socket dust cover 4. Remove the microprocessor air baffle Note The microprocessor fits only one way on the socket 8. Install a heat sink on the microprocessor Installing an adapter Low-profile PCI Express adapterPCI riser card Access holes Release tabsInstalling a Remote Supervisor Adapter II SlimLine Hard disk drive cable connector 4Hard disk drive cable connector 0 Battery3. Remove the cover 4. Remove the PCI riser-card assembly Replacing the ServeRAID SAS controller Completing the installation Front view Installing the coverConnecting the cables Updating the server configuration Rear viewIf you have installed or removed a hard disk drive, see “Usingthe RAID configuration programs” on page 44 for information about reconfiguring the disk arrays Page Chapter 3. Server controls, LEDs, and power Front viewPower-on LED System-error LEDPower-control button Hard disk drive activity LEDRear view Chapter 3. Server controls, LEDs, and powerServer power features Turning on the server Turning off the serverPage User Guide on the ThinkServer Documentation DVD Chapter 4. Configuring the serverUsing the ThinkServer EasyStartup program Page Configuring the Gigabit Ethernet controllers Using ThinkServer EasyManage productsUsing the Configuration/Setup Utility program Using the RAID configuration programs Using the IBM ServeRAID Configuration Utility programUsing ServeRAID Manager Starting the IBM ServeRAID Configuration Utility programIBM ServeRAID Configuration Utility menu choices Configuring the RAID controller2. Click Custom configuration Viewing the configuration2. Click Express configuration Using the baseboard management controller BIOS update and configurationLinux configuration Red Hat Enterprise Linux ES 4 configurationLILO configuration If you are using LILO, complete the following steps Original /etc/lilo.conf contents 2. Run the lilo command to store and activate the LILO configuration Original /boot/grub/grub.conf contents SUSE SLES 9.0 configuration Modified /boot/grub/grub.conf contentsOriginal /boot/grub/menu.lst contents Modified /boot/grub/menu.lst contentsb. Add the following line before the first title line c. Append the following text to the first title lineMicrosoft Windows 2003 Standard Edition configuration COM1 and that redirectbaudrate is set toInstalling the OSA SMBridge management utility program 3. Follow the prompts to complete the installation 3. Type mount/mnt/cdromUsing the baseboard management controller utility programs Page Page Chapter 5. Solving problems Diagnostic tools overviewPOST beep codes v Diagnostics DVDOther beep codes POST error codes problem foundPOST Failing device orEasyStartup problems SymptomTable 8. ThinkServer EasyStartup DVD ActionTroubleshooting tables CD-RW/DVD drive problemsGeneral problems Hard disk drive problemsIntermittent problems the Hardware Maintenance ManualUSB keyboard, mouse, or pointing-device problems Memory problems Hardware Maintenance ManualMicroprocessor problems LEDs” in the Hardware Maintenance ManualMonitor problems Page Optional-device problems Power problemsSymptom Serial port problems Software problems Light path diagnostics Universal Serial Bus USB port problemsVideo problems Diagnosing problems using light path diagnostics Light path diagnostics LEDsthe User Guide on the ThinkServer Documentation DVD for Description Before you call Using the documentationAppendix A. Getting help and technical assistance Calling for service Getting help and information from the World Wide WebUsing other services Purchasing additional servicesLenovo product service Appendix A. Getting help and technical assistancePage Morrisville, NC U.S.A Attention Lenovo Director of Licensing Appendix B. NoticesLenovo United States, Inc 1009 Think Place - Building One Trademarks Important notesWaste electrical and electronic equipment WEEE notices Appendix B. NoticesBattery return program For the European UnionGerman Ordinance for Work gloss statement Electronic emissions noticesFederal Communications Commission FCC statement For CaliforniaUnited Kingdom telecommunications safety requirement Industry Canada Class A emission compliance statementAvis de conformité à la réglementation dIndustrie Canada Australia and New Zealand Class A statementJapanese Voluntary Control Council for Interference VCCI statement DeutschlandBetriebsmittein Das Gerät erfüllt die Schutzanforderungen nach EN 55024 und ENTaiwanese Class A warning statement Chinese Class A warning statement Korean Class A warning statementIndex A See SAS Index software problemsconnectors Page Page Part Number 46U0862 Printed in USA 1P P/N 46U0862