Introduction
Part names
Projector
(1) Lamp cover (
89) The lamp unit is inside.
(2) Speakers (x2) (
19, 46)
(3) Filter cover (
91)
The air filter and intake vent are inside.
(4) Elevator feet (x2) (
22)
(5) Elevator buttons (x2) (
22)
(6) Remote sensor (
16)
(7) Lens (
94)
(8) Lens cover
(9) Pocket caps
(10) Intake vents
(11) Control panel (
5)
(12) Lens adjuster door (
5)
The adjusters for the lens are behind the door.
(13) AC IN (AC inlet) (
15)
(14) Exhaust vent
(15) Rear panel (
5)
(16) Security bar (
15)
(17)Battery cover (
93)
The internal clock battery is inside.
(18)Heel
WARNING ►Do not open or remove any portion of the product, unless the manuals direct it.
►Do not subject the projector to unstable conditions. ►Do not apply a shock or pressure to this product.
►Do not look into the lens and the openings on the projector while the lamp is on.
►Keep the pocket caps away from children and pets. Make sure they do not swallow the caps. If swallowed consult a physician immediately for emergency treatment.
CAUTION ►Do not touch around the lamp cover and the exhaust vents during use or just after use, since it is too hot.
►Do not attach anything onto the lens except the lens cover of this projector because it could damage the lens, such as melting the lens.
(continued on next page)
4