Oki 7100e+ Network Print Server Part Names, 100BASE-TX/10BASE-T Connector, Stat Light red LED

Page 9

4Re-attach the rear cover, and fasten it with two screws.

CAUTION: Be careful not to pinch the left parallel cable clamp.

Network Print Server Part Names

100BASE-TX/10BASE-T Connector

This should be connected using a twisted pair cable.

Switching between 100BASETX and 10BASE-T is automatic.

STAT Light (red LED)

Flashes when the network print server receives data. If the network print server detects an abnormality, the STAT light performs one of the following:

∑Flashes at fixed intervals ∑Stays on

∑Stays off.

User’s Guide: English 9

Image 9

Contents 59324102 User’s GuideNetwork print server Contents Troubleshooting Specifications IndexNovell NetWare Components IntroductionNetwork print server Adapter CardOKI Print Monitor Utility HP JetAdmin and Web JetAdmin SupportNetwork print server Installation Network print server 100BASE-TX/10BASE-T Connector Network Print Server Part NamesStat Light red LED Link 10M Light green LED, near cable Link 100M Light green LED, centerSetting Up the Network Print Server Using Okiview Network Print Server ConfigurationOkiview 32 Printer Properties Menu Okiview 32 Printer PanelStatus Network PropertiesNovell List Panel Novell ConfigurationNovell Information Panel Changing the Printerís Name and LocationIP Address Setup Repeat for 84SUBNET Mask and 85DEFAULTPressMENU/EXIT Using the Network print server Web T p / / 1 9 3 3 2 TCP/IP Settings SettingsNetWare Settings Print Server ModeFile Servers per Pserver Mode NetBEUI SettingsEtherTalk Settings Snmp Settings Connecting Using TCP/IPMIB-II Category Printer MenuConnecting One Printer and One Computer Using TelnetPrinter Address Subnet Mask Arp -s 192.168.20.127 0080920011BC tempSettings Main screen DHCP/BOOTP protocol TCP/IP setup screenRoot password Back to prior menu Please select 1 99? Snmp setup screenPacket type 802.3 NetWare mode NetWare setup screenNetWare print server mode setup screen Please select 1-99? Message Value NetWare protocolMessage Value Pserver name Job timeout Back to prior menu Please select 1-99? Message Value EtherTalk protocolZone Name Back to prior menu Please select 1 99? Printer trap setup screen Resetting the fax machinePlease select 1-99? Message Value Trap enable Trap typeWindows Printing OverviewAdd Printer Driver Network Print Server Setup for Windows Network print server User’s Guide English Network print server Add the LPR Port Network print server Pop-Up Monitor Task TrayPrinter Selection Always display on top Monitor ScreenStatus Monitoring Setup DialogPop-Up Conditions Display User’s Guide English Remote Printer Mode Print Server ModeNovell NetWare IntroductionSetting up the Network Print Server Using Bindery PrintingClick Novell Novell Directory Services NDS Setting up the Network Print Server using OkiviewVerifying that the Printer is Connected Click OK Click Change ContextClick Add/Delete Queue Click OK. Then Click OK in the Printer PropertiesNovell Distributed Print Services Ndps Setting up the ClientsAdd Printer Wizard will start Troubleshooting Fax machine cannot find the network print serverFax machine does not print via lpr or ftp User name in banner Problems printing via NetWareFax machine does not print If the ROM check or RAM check result is NG no good Problems printing self diagnostics test and configurationIf the Eeprom check result is NG If NIC Check is marked with NGNetwork print server Status Lights Network Interface SpecificationsNetwork Protocol FunctionsIndex Network print server