Black Box COMPACT T1 quick start External Alarm Connector, Pin # Description Explanation

Page 19

Quick Start

Interface Connectors

External Alarm Connector

The external alarm 6-pin connector with one input pair (pins 5 and 6)

and two output pairs (pins 1 and 2 - major alarms; pins 3 and 4 - minor A

alarms).

L

A

R

M

6

5

4

3

2 1

The pinouts are as follows:

Pin #

Description

Explanation

 

 

 

1

Major Alarm +

The major alarm output is available for power supply or

2

Major Alarm -

major alarm failure alerting. The maximum voltage across

the contacts is 350 V, and the maximum current is 150 mA.

 

 

 

 

This alarm is closed when power is off.

 

 

 

3

Minor Alarm +

The minor alarm output is available for power supply or

4

Minor Alarm -

minor alarm failure alerting. The maximum voltage across

the contacts is 350 V, and the maximum current is 150 mA.

 

 

 

 

This alarm remains open when power is off.

 

 

 

5

Alarm In +

The alarm inputs provide 5 VDC across the two contacts,

6

Alarm In -

and generate an alarm when a short circuit is detected

between the contacts.

 

 

 

 

The alarm generated is a minor severity alarm.

 

 

 

Compact T1 - Release 6.1

15

Image 19
Contents Compact T1 Supporting Software Version Preface Safety InformationElectrostatic Discharge ESD Precautions Quick Start Unpacking and Inspection Installation EnvironmentAssembly of Compact T1 Wall Mounting To rack mount the Unit, follow the instructions below Rack Mounting Optional FeatureHeat Baffle Left Side View Thumbscrew Quick Start Power Cables Compliant InstallationFerrite Beads Service Card Cables that Require Additional Ferrite BeadsFerrite Beads shipped with Adit chassis Interface Connectors Chassis Connectors and ButtonsGround Terminals Chassis Ground Connector48V Battery Power ResetPower Connections AC PowerTo connect -48 VDC power Pin # Description Explanation External Alarm ConnectorPair Pin Location Function Color Code Pair Telco ConnectorsQuick Start Direction Description RS-232 Craft Port Female DB-9Ethernet RJ-45 T1 Connection Ports10Base-T Ethernet T1 RJ-48CLocal and Remote Management Option Command Line Interface CLISetting up a CLI connection Set the port settings to 9600 baud 8/N/1/No Flow ControlConfiguration Set Up Security Initial SetupCommand Set Up a DS0/Channel Set Up a DS1/T1Set Up an Analog Port Set Up the Router IP or CMG Cards Establish a Static Channel Connection Set Up a Isdn BRI ServiceSet Up the OCU-DP Card Change the IP Address of the DS0 Management Channel Set Up a V.35 PortUpgrade the Router IP or CMG Software Upgrade the Controller SoftwareInstall Country Specific Ringer Tones T1 Controller Card Dip SwitchesSwitch Function Description Controller CardsState Description LEDs115 VAC/-48 VDC Power Supply Power SuppliesDIP Switch Settings Service CardsFXO Card FXS Intl card FXS CardOCU-DP Card Isdn BRI Card35/V.54 Card Quad T1 CardCRD CMG Router CardCOL IP Router Card