Black Box COMPACT T1 quick start Electrostatic Discharge ESD Precautions

Page 4

Preface

Electrostatic Discharge (ESD) Precautions

Electrostatic Discharge (ESD) Precautions

ESD can damage processors, circuit cards, and other electronic components. Always observe the following precautions before installing a system component.

1.Do not remove a component from its protective packaging until ready to install it.

2.Wear a wrist grounding strap and attach it to a metal part of the system unit before handling components. If a wrist strap is not available, maintain contact with the system unit throughout any procedure requiring ESD protection.

WARNING! INTEGRATED CIRCUITS (ICS) ARE EXTREMELY SUSCEPTIBLE TO ELECTROSTATIC DISCHARGE. UNLESS YOU ARE A QUALIFIED SERVICE TECHNICIAN WHO USES TOOLS AND TECHNIQUES THAT CONFORM TO ACCEPTED INDUSTRY PRACTICES, DO NOT HANDLE ICS.

The ESD warning label appears on packages and storage bags that contain static-sensitive products and components.


4	Compact T1 - Release 6.1

Image 4

Contents Compact T1 Supporting Software Version Safety Information PrefaceElectrostatic Discharge ESD Precautions Quick Start Installation Environment Unpacking and InspectionAssembly of Compact T1 Wall Mounting Rack Mounting Optional Feature To rack mount the Unit, follow the instructions belowHeat Baffle Left Side View Thumbscrew Quick Start Compliant Installation Power CablesFerrite Beads Service Card Cables that Require Additional Ferrite BeadsFerrite Beads shipped with Adit chassis Chassis Connectors and Buttons Interface ConnectorsChassis Ground Connector Ground TerminalsPower Reset Power ConnectionsAC Power 48V BatteryTo connect -48 VDC power External Alarm Connector Pin # Description ExplanationPair Telco Connectors Pair Pin Location Function Color CodeQuick Start RS-232 Craft Port Female DB-9 Direction DescriptionT1 Connection Ports 10Base-T EthernetT1 RJ-48C Ethernet RJ-45Command Line Interface CLI Setting up a CLI connectionSet the port settings to 9600 baud 8/N/1/No Flow Control Local and Remote Management OptionConfiguration Set Up Security Initial SetupCommand Set Up a DS1/T1 Set Up a DS0/ChannelSet Up an Analog Port Set Up the Router IP or CMG Cards Set Up a Isdn BRI Service Establish a Static Channel ConnectionSet Up the OCU-DP Card Set Up a V.35 Port Change the IP Address of the DS0 Management ChannelUpgrade the Router IP or CMG Software Upgrade the Controller SoftwareInstall Country Specific Ringer Tones Dip Switches Switch Function DescriptionController Cards T1 Controller CardLEDs State DescriptionPower Supplies 115 VAC/-48 VDC Power SupplyDIP Switch Settings Service CardsFXO Card FXS Card FXS Intl cardIsdn BRI Card OCU-DP CardQuad T1 Card 35/V.54 CardCMG Router Card CRDIP Router Card COL