Black Box COMPACT T1 quick start Local and Remote Management Option, Command Line Interface CLI

Page 24

Quick Start

Local and Remote Management Option

Local and Remote Management Option

This Quick Start Guide will focus on CLI and DIP switches. If you need further information on other management options, please refer to the Compact T1 User Manual.

λLocal using CLI, Telnet, SNMP or DIP Switches (Controller and voice cards)

λRemotely over an in-band DS0 or through the Access Navigator over the FDL or an in-band DS0

Command Line Interface (CLI)

You can access the CLI using either of the following methods:

λRS-232 connected to the DB-9 port.

λTelnet via Ethernet (10Base-T)

Setting up a CLI connection

To connect to the CLI via the RS-232 port, set up a connection to a PC serial port or dumb terminal using Hyperterm, ProComm, or similar terminal emulation software:

λSet the port settings to: 9600 baud 8/N/1/No Flow Control

λSet the terminal emulation screen size to 24 lines by 80 characters.

λThe Compact T1 default is set configure locally (using DIP switches). Use the set local off command to enable the use of CLI commands.

20	Compact T1 - Release 6.1

Image 24

Contents Compact T1 Supporting Software Version Safety Information PrefaceElectrostatic Discharge ESD Precautions Quick Start Installation Environment Unpacking and InspectionAssembly of Compact T1 Wall Mounting Rack Mounting Optional Feature To rack mount the Unit, follow the instructions belowHeat Baffle Left Side View Thumbscrew Quick Start Compliant Installation Power CablesService Card Cables that Require Additional Ferrite Beads Ferrite BeadsFerrite Beads shipped with Adit chassis Chassis Connectors and Buttons Interface ConnectorsChassis Ground Connector Ground TerminalsPower Reset Power ConnectionsAC Power 48V BatteryTo connect -48 VDC power External Alarm Connector Pin # Description ExplanationPair Telco Connectors Pair Pin Location Function Color CodeQuick Start RS-232 Craft Port Female DB-9 Direction DescriptionT1 Connection Ports 10Base-T EthernetT1 RJ-48C Ethernet RJ-45Command Line Interface CLI Setting up a CLI connectionSet the port settings to 9600 baud 8/N/1/No Flow Control Local and Remote Management OptionConfiguration Initial Setup Set Up SecurityCommand Set Up a DS1/T1 Set Up a DS0/ChannelSet Up an Analog Port Set Up the Router IP or CMG Cards Set Up a Isdn BRI Service Establish a Static Channel ConnectionSet Up the OCU-DP Card Set Up a V.35 Port Change the IP Address of the DS0 Management ChannelUpgrade the Controller Software Upgrade the Router IP or CMG SoftwareInstall Country Specific Ringer Tones Dip Switches Switch Function DescriptionController Cards T1 Controller CardLEDs State DescriptionPower Supplies 115 VAC/-48 VDC Power SupplyService Cards DIP Switch SettingsFXO Card FXS Card FXS Intl cardIsdn BRI Card OCU-DP CardQuad T1 Card 35/V.54 CardCMG Router Card CRDIP Router Card COL