Black Box COMPACT T1 quick start Power Reset, Power Connections, AC Power, 48V Battery

Page 17

Quick Start

Interface Connectors

Power Reset

This is a resetable circuit breaker. If at any time there is a short or power surge on the incoming AC/DC line, the breaker will trip to protect the Power supply from damage.

Power Connections

AC Power

The AC Power cord is a standard AC Power cord and is

 

provided with a 115 VAC Power Supply.

 

To connect the Power Cord:

AC Power Connector

1.Insert power cord (male-end) to AC power source.

2.Plug connector into the Unit.

3.A green light should appear on the DC Input LED on the front of the Power Supply.

-48V Battery

The -48 VDC input connector on the Unit is used for either direct DC powering of the Unit or for a Battery Backup connection when AC is used. There is no power cable provided for this connector, however the connector is provided.

The pinouts are as follows:

Pin #

Description

1

(+)

Battery return

 

 

 

2

(-)

-48VDC

 

 

 

1(+) 2(-)

Connector on back of Unit (male)

WARNING! POSSIBLE SHOCK HAZARD EXISTS, PLEASE FOLLOW INSTRUCTIONS CAREFULLY.

Compact T1 - Release 6.1

13

Image 17
Contents Compact T1 Supporting Software Version Preface Safety InformationElectrostatic Discharge ESD Precautions Quick Start Unpacking and Inspection Installation EnvironmentAssembly of Compact T1 Wall Mounting To rack mount the Unit, follow the instructions below Rack Mounting Optional FeatureHeat Baffle Left Side View Thumbscrew Quick Start Power Cables Compliant InstallationFerrite Beads shipped with Adit chassis Service Card Cables that Require Additional Ferrite BeadsFerrite Beads Interface Connectors Chassis Connectors and ButtonsGround Terminals Chassis Ground ConnectorPower Connections Power ResetAC Power 48V BatteryTo connect -48 VDC power Pin # Description Explanation External Alarm ConnectorPair Pin Location Function Color Code Pair Telco ConnectorsQuick Start Direction Description RS-232 Craft Port Female DB-910Base-T Ethernet T1 Connection PortsT1 RJ-48C Ethernet RJ-45Setting up a CLI connection Command Line Interface CLISet the port settings to 9600 baud 8/N/1/No Flow Control Local and Remote Management OptionConfiguration Command Initial SetupSet Up Security Set Up a DS0/Channel Set Up a DS1/T1Set Up an Analog Port Set Up the Router IP or CMG Cards Establish a Static Channel Connection Set Up a Isdn BRI ServiceSet Up the OCU-DP Card Change the IP Address of the DS0 Management Channel Set Up a V.35 PortInstall Country Specific Ringer Tones Upgrade the Controller SoftwareUpgrade the Router IP or CMG Software Switch Function Description Dip SwitchesController Cards T1 Controller CardState Description LEDs115 VAC/-48 VDC Power Supply Power SuppliesFXO Card Service CardsDIP Switch Settings FXS Intl card FXS CardOCU-DP Card Isdn BRI Card35/V.54 Card Quad T1 CardCRD CMG Router CardCOL IP Router Card