Black Box COMPACT T1 quick start Set Up the OCU-DP Card

Page 31

Quick Start

Configuration

Set Up the OCU-DP Card

The following is a basic setup for the OCU-DP card.

Command

set {ocudp-addr} baud {2400480096001920038400 56000*64000}

set {ocudp-addr} up

show {ocudp_card-addr}

disconnect a

set {ds0-addr} type data

connect {ds0-addr} {ocudp-addr}

show connect (ocudp_card-addr}

Description

Set the OCU-DP Baud rate.

Where ocudp-addr = {slot:port} of the OCU-DP card to apply settings to.

Set the OCU-DP port 1 up.

Show the OCU-DP card settings. Where ocudp_card-addr = {slot} of the OCU-DP card.

Disconnects all connections to slot a (controller)

Sets a DS0 data signaling type

Connects DS0 (in previous step) to OCU-DP port (in previous step).

Displays connect information for OCU-DP card.

Compact T1 - Release 6.1

27

Image 31

Contents Compact T1 Supporting Software Version Preface Safety InformationElectrostatic Discharge ESD Precautions Quick Start Unpacking and Inspection Installation EnvironmentAssembly of Compact T1 Wall Mounting To rack mount the Unit, follow the instructions below Rack Mounting Optional FeatureHeat Baffle Left Side View Thumbscrew Quick Start Power Cables Compliant InstallationFerrite Beads Service Card Cables that Require Additional Ferrite BeadsFerrite Beads shipped with Adit chassis Interface Connectors Chassis Connectors and ButtonsGround Terminals Chassis Ground Connector48V Battery Power ResetPower Connections AC PowerTo connect -48 VDC power Pin # Description Explanation External Alarm ConnectorPair Pin Location Function Color Code Pair Telco ConnectorsQuick Start Direction Description RS-232 Craft Port Female DB-9Ethernet RJ-45 T1 Connection Ports10Base-T Ethernet T1 RJ-48CLocal and Remote Management Option Command Line Interface CLISetting up a CLI connection Set the port settings to 9600 baud 8/N/1/No Flow ControlConfiguration Set Up Security Initial SetupCommand Set Up a DS0/Channel Set Up a DS1/T1Set Up an Analog Port Set Up the Router IP or CMG Cards Establish a Static Channel Connection Set Up a Isdn BRI ServiceSet Up the OCU-DP Card Change the IP Address of the DS0 Management Channel Set Up a V.35 PortUpgrade the Router IP or CMG Software Upgrade the Controller SoftwareInstall Country Specific Ringer Tones T1 Controller Card Dip SwitchesSwitch Function Description Controller CardsState Description LEDs115 VAC/-48 VDC Power Supply Power SuppliesDIP Switch Settings Service CardsFXO Card FXS Intl card FXS CardOCU-DP Card Isdn BRI Card35/V.54 Card Quad T1 CardCRD CMG Router CardCOL IP Router Card