Black Box COMPACT T1 quick start Wall Mounting

Page 8

Quick Start

Wall Mounting

Wall Mounting

Before beginning the mounting process, verify that the area meets the following requirements:

λA stable environment, clean and free from extremes of temperature, shock, vibration and EMI, that meets the all installation environment requirements, see Installation Environment on page 1-2.

Leave adequate clearance at the back for access to connectors

Leave at least 3.5" above and below the Unit for adequate ventilation

Mounting Bracket

Leave at least 14" at the front of the unit for access to cards and DIP switches

The Unit is delivered with a mounting bracket attached for quick and easy wall mounting, as shown in the illustration above.

To install the unit to the wall, attach the unit using the four screws provided, one at each bracket foot.

NOTE: Do not mount the Unit in any other orientation as show above.

4	Compact T1 - Release 6.1

Image 8

Contents Compact T1 Supporting Software Version Safety Information PrefaceElectrostatic Discharge ESD Precautions Quick Start Installation Environment Unpacking and InspectionAssembly of Compact T1 Wall Mounting Rack Mounting Optional Feature To rack mount the Unit, follow the instructions belowHeat Baffle Left Side View Thumbscrew Quick Start Compliant Installation Power CablesFerrite Beads shipped with Adit chassis Service Card Cables that Require Additional Ferrite BeadsFerrite Beads Chassis Connectors and Buttons Interface ConnectorsChassis Ground Connector Ground TerminalsPower Reset Power ConnectionsAC Power 48V BatteryTo connect -48 VDC power External Alarm Connector Pin # Description ExplanationPair Telco Connectors Pair Pin Location Function Color CodeQuick Start RS-232 Craft Port Female DB-9 Direction DescriptionT1 Connection Ports 10Base-T EthernetT1 RJ-48C Ethernet RJ-45Command Line Interface CLI Setting up a CLI connectionSet the port settings to 9600 baud 8/N/1/No Flow Control Local and Remote Management OptionConfiguration Command Initial SetupSet Up Security Set Up a DS1/T1 Set Up a DS0/ChannelSet Up an Analog Port Set Up the Router IP or CMG Cards Set Up a Isdn BRI Service Establish a Static Channel ConnectionSet Up the OCU-DP Card Set Up a V.35 Port Change the IP Address of the DS0 Management ChannelInstall Country Specific Ringer Tones Upgrade the Controller SoftwareUpgrade the Router IP or CMG Software Dip Switches Switch Function DescriptionController Cards T1 Controller CardLEDs State DescriptionPower Supplies 115 VAC/-48 VDC Power SupplyFXO Card Service CardsDIP Switch Settings FXS Card FXS Intl cardIsdn BRI Card OCU-DP CardQuad T1 Card 35/V.54 CardCMG Router Card CRDIP Router Card COL