Black Box COMPACT T1 quick start Quad T1 Card, 35/V.54 Card

Page 40

Quick Start

Service Cards

Quad T1 Card

Each channel on the Quad T1 card has two LEDs. The description of the top LED is shown below, the bottom LED is not used with this application.

State	Description

Off	Off line

Green	Normal

Red	Loss of Signal (LOS)

Yellow	Bipolar Violation (BPV)

Flashing Green	Loopback active

Flashing Yellow	Yellow Alarm
	(Remote Alarm Indication)

Flashing Red (Slow)	Loss of Frame (LOF) or Alarm Indication Signal (AIS)

Flashing Red (Fast)	Self-test Failure

V.35/V.54 Card

Each V.35 port has its own LED, as shown in the table below.

State	Description
Off	No T1 Assignment

Green	Normal (CD/RTS) Active

Red	CD inactive (T1-side failure)

Yellow	RTS inactive (equipment-side failure)

Flashing Yellow	Loopback toward T1 or equipment loop test

Flashing Green	Loopback toward equipment or network loop test

36	Compact T1 - Release 6.1

Image 40

Contents Compact T1 Supporting Software Version Safety Information PrefaceElectrostatic Discharge ESD Precautions Quick Start Installation Environment Unpacking and InspectionAssembly of Compact T1 Wall Mounting Rack Mounting Optional Feature To rack mount the Unit, follow the instructions belowHeat Baffle Left Side View Thumbscrew Quick Start Compliant Installation Power CablesFerrite Beads Service Card Cables that Require Additional Ferrite BeadsFerrite Beads shipped with Adit chassis Chassis Connectors and Buttons Interface ConnectorsChassis Ground Connector Ground TerminalsPower Reset Power ConnectionsAC Power 48V BatteryTo connect -48 VDC power External Alarm Connector Pin # Description ExplanationPair Telco Connectors Pair Pin Location Function Color CodeQuick Start RS-232 Craft Port Female DB-9 Direction DescriptionT1 Connection Ports 10Base-T EthernetT1 RJ-48C Ethernet RJ-45Command Line Interface CLI Setting up a CLI connectionSet the port settings to 9600 baud 8/N/1/No Flow Control Local and Remote Management OptionConfiguration Set Up Security Initial SetupCommand Set Up a DS1/T1 Set Up a DS0/ChannelSet Up an Analog Port Set Up the Router IP or CMG Cards Set Up a Isdn BRI Service Establish a Static Channel ConnectionSet Up the OCU-DP Card Set Up a V.35 Port Change the IP Address of the DS0 Management ChannelUpgrade the Router IP or CMG Software Upgrade the Controller SoftwareInstall Country Specific Ringer Tones Dip Switches Switch Function DescriptionController Cards T1 Controller CardLEDs State DescriptionPower Supplies 115 VAC/-48 VDC Power SupplyDIP Switch Settings Service CardsFXO Card FXS Card FXS Intl cardIsdn BRI Card OCU-DP CardQuad T1 Card 35/V.54 CardCMG Router Card CRDIP Router Card COL