Black Box COMPACT T1 quick start Chassis Connectors and Buttons, Interface Connectors

Page 15

Quick Start

Chassis Connectors and Buttons

Chassis Connectors and Buttons

The following illustrations show all connectors on the back of the unit.

AC Power Connector

Alarms

Reset

Ground Terminals

-48V/Battery

Ethernet [10Base-T]

T1-2

T1

Connectors

T1-1

25-Pair Telco Connectors

RS-232 Craft Port

Interface Connectors

The following are the Compact T1 chassis interface connectors:

λT1-1 and T1-2 line connection ports each equipped with standard RJ-48C 8-pin connector jack

λRS-232 craft port connector

λTip and Ring Analog Interfaces equipped with standard 25-pair Telco Connectors

λ10Base-T Ethernet port to be connected to a remote management tool such as Telnet or an SNMP-based Network Management System with an RJ-45 8-pin connector jack

λExternal Alarm Connector

λGround Lugs

Compact T1 - Release 6.1

11

Image 15

Contents Compact T1 Supporting Software Version Preface Safety InformationElectrostatic Discharge ESD Precautions Quick Start Unpacking and Inspection Installation EnvironmentAssembly of Compact T1 Wall Mounting To rack mount the Unit, follow the instructions below Rack Mounting Optional FeatureHeat Baffle Left Side View Thumbscrew Quick Start Power Cables Compliant InstallationService Card Cables that Require Additional Ferrite Beads Ferrite BeadsFerrite Beads shipped with Adit chassis Interface Connectors Chassis Connectors and ButtonsGround Terminals Chassis Ground Connector48V Battery Power ResetPower Connections AC PowerTo connect -48 VDC power Pin # Description Explanation External Alarm ConnectorPair Pin Location Function Color Code Pair Telco ConnectorsQuick Start Direction Description RS-232 Craft Port Female DB-9Ethernet RJ-45 T1 Connection Ports10Base-T Ethernet T1 RJ-48CLocal and Remote Management Option Command Line Interface CLISetting up a CLI connection Set the port settings to 9600 baud 8/N/1/No Flow ControlConfiguration Initial Setup Set Up SecurityCommand Set Up a DS0/Channel Set Up a DS1/T1Set Up an Analog Port Set Up the Router IP or CMG Cards Establish a Static Channel Connection Set Up a Isdn BRI ServiceSet Up the OCU-DP Card Change the IP Address of the DS0 Management Channel Set Up a V.35 PortUpgrade the Controller Software Upgrade the Router IP or CMG SoftwareInstall Country Specific Ringer Tones T1 Controller Card Dip SwitchesSwitch Function Description Controller CardsState Description LEDs115 VAC/-48 VDC Power Supply Power SuppliesService Cards DIP Switch SettingsFXO Card FXS Intl card FXS CardOCU-DP Card Isdn BRI Card35/V.54 Card Quad T1 CardCRD CMG Router CardCOL IP Router Card