Xerox 2750 manual Exiting Handfeed Mode

Page 20

There are two parameters available to the service technician to customize the hand feeding process to suit individual operator preferences:

•Handfeed delay: Determines the amount of time that the infeed sensor is covered before the tower rollers pull the document in. The delay is selectable from 0 through 10 seconds (2 seconds is the default condition). Some users prefer a longer delay to allow more time to square up the document.

•Handfeed ramping time: This is the “oops” provision. It determines the time the operator has available, after the tower rollers begin to turn, to pull the print out without causing an error condition.

Exiting Handfeed Mode ...

Once hand feeding jobs are completed, press the HANDFEED button to return the folder to online operation. The LED will go out and the display will return to its previous state – normally ONLINE. Any print jobs sent to the controller while the folder is in Handfeed Mode are stored and begin automatically.

Notes:

1)While the folder is in Handfeed Mode, it will appear as a “Finisher Error” to the print controller.

2)If the folder is left idle in Handfeed Mode for 10 minutes it will automatically return to Online Mode.

3)If power is cycled while the folder is in Handfeed Mode, it will return to Online Mode on power-up.

2750 op#2 R3.doc 10-02

Page 2-7

Image 20

Contents PRINTFOLD Synergix Fold System Engineering Document Folder Main components of the Model 2750 Folder General informationSynergix Fold System Power entry module / counter / communications port Operator’s control panelMain control panel Instant service access BridgeStacker/Handfeed Automatic document diversionTower in normal folding and bypass modes Manual feed slotAccordion folding overview Standard accordion fold packetType F bookfold packet Crossfolding overview Folds handle easier than Z-foldsLEL = non-standard feed direction Key facts about fold programsSEL = standard feed direction Width sensors at input end of bridge Main features of the 2750 folding system Options availableModel 2750 Folder operator’s side After installationPower entry panel Operator’s controls ½ x 11 C-folded packet, landscape style12 Z-folded packet, portrait style BkaZ ½ x 11 book-folded packet Z fold onlyFold Selection Host controller Start-upReset procedure Fold Selection StandaloneOn-line programs Hand feed programsManual document feeding Rear of diverter tower, showing stacker/off-line componentsTo begin hand feeding Hand feeding a documentExiting Handfeed Mode Jam conditions Clearing a jamBridge and Bridge Exit If the document is visibleRaising the bridge lid Unlocking the bridgeRaising the bridge Access to the towerTower Use the jog feature … Accordion FolderAccordion folder lid in raised position Opening the upper clam shellEjector springs on crank handle Using the crank handle to rotate the drumRaising the drum faceplate shutter Upper section of the crossfolder in raised position CrossfolderCrossfolder latches Crossfold Transfer Crossfold Pocket and Crossfold ExitCrossfolder rear panel Unhitching the accordion and cross folderCrossfold pocket Interlock OpenCrank handle engaged in crossfold roll System Error In-feed and accordion folding components Initial phase of the folding programAccordion Folder Completion of the first fold Panel measuring phaseDrum reversal develops a loop Starting the second fold Accordion fold compensating panelsFirst crossfold action Document inversionCrossfolder Single crossfold mode Double crossfold modeOperator’s control panel System MenuPasswords Communications modeJog functions Parameter viewing and modificationAccessible only to the Key Operator and technician Device testSheets 1s 3 0 5 Recent errorsActivity counters 721p Synergix Fold System 40 & XES 2750 Series fold tables DescriptionAfnor Fold Banks Peco Fold MIXFold Bank 1 common European sizes Folder Error Messages Message Definition Location or type of error