Xerox 2750 manual Synergix Fold System Engineering Document Folder

Page 2

PRINTFOLD

MODEL 2750

&

SYNERGIX FOLD SYSTEM 40

ENGINEERING DOCUMENT FOLDER

	OPERATOR’S MANUAL
	Table of Contents
Chapter 1	Introduction
Chapter 2	Operating Instructions
Chapter 3	Outline of Folding Mechanism
Chapter 4	System Menu and Key Operator Functions

WARNING

The interlock system is designed to prevent access to components capable of causing injury. Do not try to defeat any interlock by taping or otherwise artificially holding it closed.

WARNING

Line voltage (115 or 230Vac) is present at exposed points on the accordion folder base frame (back of the power entry module, and at fuses on the power supply board). This applies whether or not the interlock circuit is intact. Access to these danger points is prevented by a plastic panel at the rear of the accordion folder, which must not be removed by other than a qualified service technician.

2750 op#0_2 R3.doc 10-02

Image 2

Contents PRINTFOLD Synergix Fold System Engineering Document Folder Main components of the Model 2750 Folder General informationSynergix Fold System Power entry module / counter / communications port Operator’s control panelMain control panel Stacker/Handfeed Instant service accessBridge Automatic document diversionTower in normal folding and bypass modes Manual feed slotAccordion folding overview Standard accordion fold packetType F bookfold packet Crossfolding overview Folds handle easier than Z-foldsLEL = non-standard feed direction Key facts about fold programsSEL = standard feed direction Width sensors at input end of bridge Main features of the 2750 folding system Options availableModel 2750 Folder operator’s side After installationPower entry panel 12 Z-folded packet, portrait style Operator’s controls½ x 11 C-folded packet, landscape style BkaZ ½ x 11 book-folded packet Z fold onlyFold Selection Host controller Start-upOn-line programs Reset procedureFold Selection Standalone Hand feed programsManual document feeding Rear of diverter tower, showing stacker/off-line componentsTo begin hand feeding Hand feeding a documentExiting Handfeed Mode Jam conditions Clearing a jamRaising the bridge lid Bridge and Bridge ExitIf the document is visible Unlocking the bridgeRaising the bridge Access to the towerTower Accordion folder lid in raised position Use the jog feature …Accordion Folder Opening the upper clam shellEjector springs on crank handle Using the crank handle to rotate the drumRaising the drum faceplate shutter Upper section of the crossfolder in raised position CrossfolderCrossfolder latches Crossfolder rear panel Crossfold TransferCrossfold Pocket and Crossfold Exit Unhitching the accordion and cross folderCrossfold pocket Interlock OpenCrank handle engaged in crossfold roll System Error In-feed and accordion folding components Initial phase of the folding programAccordion Folder Completion of the first fold Panel measuring phaseDrum reversal develops a loop Starting the second fold Accordion fold compensating panelsFirst crossfold action Document inversionCrossfolder Single crossfold mode Double crossfold modeOperator’s control panel System MenuJog functions PasswordsCommunications mode Parameter viewing and modificationAccessible only to the Key Operator and technician Device testSheets 1s 3 0 5 Recent errorsActivity counters 721p Synergix Fold System 40 & XES 2750 Series fold tables DescriptionAfnor Fold Banks Peco Fold MIXFold Bank 1 common European sizes Folder Error Messages Message Definition Location or type of error