Xerox 2750 manual Crossfolder latches, Upper section of the crossfolder in raised position

Page 26

5.Rotate the drum in either direction to free one end of the document. Grasp and remove the document. Close and lock the clam shell, then close the accordion folder lid.

6.If the document cannot be removed as described above, it may be caught beneath the folding drum. This will require trained assistance. If you are qualified to perform this service, proceed as follows:

Switch off the folder at the power entry panel, then remove the power cord.

Raise the upper section of the crossfolder.

Remove the rear panel of the crossfold section.

Remove the hitch pin from the locating tongue between accordion and crossfold sections.

You are about to enter an area where line voltage (115 or 230Vac) is present unless you have

REMOVED THE POWER CORD.

CROSSFOLDER

Crossfolder latches

The upper section of the crossfolder is locked in place by latches on either side of the chassis. To release the upper section, press gently down on one corner at the rear of the unit, then press the plunger as shown. Release the other latch in the same way.

Gas springs weaken with age. Prop up the upper section of the crossfolder safely by other means if you feel that the gas springs do not support it adequately.

Upper section of the crossfolder in raised position

2750 op#2 R3.doc 10-02

Page 2-13

Image 26

Contents PRINTFOLD Synergix Fold System Engineering Document Folder Main components of the Model 2750 Folder General informationSynergix Fold System Power entry module / counter / communications port Operator’s control panelMain control panel Stacker/Handfeed Instant service accessBridge Automatic document diversionTower in normal folding and bypass modes Manual feed slotAccordion folding overview Standard accordion fold packetType F bookfold packet Crossfolding overview Folds handle easier than Z-foldsLEL = non-standard feed direction Key facts about fold programsSEL = standard feed direction Width sensors at input end of bridge Main features of the 2750 folding system Options availableModel 2750 Folder operator’s side After installationPower entry panel 12 Z-folded packet, portrait style Operator’s controls½ x 11 C-folded packet, landscape style BkaZ ½ x 11 book-folded packet Z fold onlyFold Selection Host controller Start-upOn-line programs Reset procedureFold Selection Standalone Hand feed programsManual document feeding Rear of diverter tower, showing stacker/off-line componentsTo begin hand feeding Hand feeding a documentExiting Handfeed Mode Jam conditions Clearing a jamRaising the bridge lid Bridge and Bridge ExitIf the document is visible Unlocking the bridgeRaising the bridge Access to the towerTower Accordion folder lid in raised position Use the jog feature …Accordion Folder Opening the upper clam shellEjector springs on crank handle Using the crank handle to rotate the drumRaising the drum faceplate shutter Upper section of the crossfolder in raised position CrossfolderCrossfolder latches Crossfolder rear panel Crossfold TransferCrossfold Pocket and Crossfold Exit Unhitching the accordion and cross folderCrossfold pocket Interlock OpenCrank handle engaged in crossfold roll System Error In-feed and accordion folding components Initial phase of the folding programAccordion Folder Completion of the first fold Panel measuring phaseDrum reversal develops a loop Starting the second fold Accordion fold compensating panelsFirst crossfold action Document inversionCrossfolder Single crossfold mode Double crossfold modeOperator’s control panel System MenuJog functions PasswordsCommunications mode Parameter viewing and modificationAccessible only to the Key Operator and technician Device testSheets 1s 3 0 5 Recent errorsActivity counters 721p Synergix Fold System 40 & XES 2750 Series fold tables DescriptionAfnor Fold Banks Peco Fold MIXFold Bank 1 common European sizes Folder Error Messages Message Definition Location or type of error