Xerox 2750 manual Crossfold Transfer, Crossfold Pocket and Crossfold Exit, Crossfolder rear panel

Page 27

When replacing the rear panel, take care not to damage the interlock switch.

Crossfolder rear panel

Remove the rear panel for access to the lower section of the crossfolder, including the hub for the crank handle used to clear jams.

Unplug the power cord before unhitching the crossfolder.

Unhitching the accordion and cross folder

Once the hitch pin has been removed, the crossfolder may be detached from the accordion folder. The lower clam shell is then accessible through the rear of the accordion folder. The lower clam shell, and its center lock, is identical to the upper.

4.Open the lower clam shell and remove the document.

5.Close and lock the lower clam shell, then reattach the crossfold section to the accordion folder.

6.Replace the hitch pin to lock the crossfold and accordion fold sections, then lower and lock the upper section of the crossfolder, and replace the rear cover.

CROSSFOLD TRANSFER

NOTE: It is normally not necessary to remove the cover from the upper section of the crossfolder. This is for service access only.

Press the two crossfolder latches, then raise the upper crossfold section. Observe the safety precaution. Remove the document, then close and lock the upper section.

CROSSFOLD POCKET and CROSSFOLD EXIT

1.Open the upper crossfold section.

2.Remove the rear panel.

3.If the fold packet is caught in the upper nip rolls, and enough of it is exposed, grasp it and pull upward to remove. You may need to use the crank handle, turning it clockwise. Be sure there are no torn pieces of paper remaining in the upper nip rolls.

2750 op#2 R3.doc 10-02

Page 2-14

Image 27

Contents PRINTFOLD Synergix Fold System Engineering Document Folder General information Synergix Fold SystemMain components of the Model 2750 Folder Operator’s control panel Power entry module / counter / communications portMain control panel Automatic document diversion Instant service accessBridge Stacker/HandfeedManual feed slot Tower in normal folding and bypass modesStandard accordion fold packet Accordion folding overviewType F bookfold packet Folds handle easier than Z-folds Crossfolding overviewKey facts about fold programs SEL = standard feed directionLEL = non-standard feed direction Width sensors at input end of bridge Options available Main features of the 2750 folding systemAfter installation Power entry panelModel 2750 Folder operator’s side BkaZ ½ x 11 book-folded packet Z fold only Operator’s controls½ x 11 C-folded packet, landscape style 12 Z-folded packet, portrait styleStart-up Fold Selection Host controllerHand feed programs Reset procedureFold Selection Standalone On-line programsRear of diverter tower, showing stacker/off-line components Manual document feedingHand feeding a document To begin hand feedingExiting Handfeed Mode Clearing a jam Jam conditionsUnlocking the bridge Bridge and Bridge ExitIf the document is visible Raising the bridge lidAccess to the tower TowerRaising the bridge Opening the upper clam shell Use the jog feature …Accordion Folder Accordion folder lid in raised positionUsing the crank handle to rotate the drum Raising the drum faceplate shutterEjector springs on crank handle Crossfolder Crossfolder latchesUpper section of the crossfolder in raised position Unhitching the accordion and cross folder Crossfold TransferCrossfold Pocket and Crossfold Exit Crossfolder rear panelInterlock Open Crank handle engaged in crossfold rollCrossfold pocket System Error Initial phase of the folding program Accordion FolderIn-feed and accordion folding components Panel measuring phase Drum reversal develops a loopCompletion of the first fold Accordion fold compensating panels Starting the second foldDocument inversion CrossfolderFirst crossfold action Double crossfold mode Single crossfold modeSystem Menu Operator’s control panelParameter viewing and modification PasswordsCommunications mode Jog functionsDevice test Accessible only to the Key Operator and technicianRecent errors Activity countersSheets 1s 3 0 5 Description 721p Synergix Fold System 40 & XES 2750 Series fold tablesAfnor Peco Fold MIX Fold BanksFold Bank 1 common European sizes Message Definition Location or type of error Folder Error Messages