Xerox 2750 manual Raising the drum faceplate shutter, Ejector springs on crank handle

Page 25

Raising the drum faceplate shutter

The drum faceplate is mounted on the drum shaft at the end nearest to the operator’s control panel.

The crank handle could cause serious injury if engaged in the drum faceplate while the folder is operating. Springs on the crank hand pins and shutters over the drum ends are designed to prevent this. Do not try to defeat these safety features.

Ejector springs on crank handle

Use the “jog” feature …

You can clear paper through the infeed rollers under power. Press the MORE button on the control panel to display System Menu, then press 1. Select Infeed Jog, forward or reverse as necessary.

Using the crank handle to rotate the drum

Open the faceplate shutter, then engage the crank handle. Because the crank handle is spring loaded, constant pressure is required to hold it in place.

2750 op#2 R3.doc 10-02

Page 2-12

Image 25

Contents PRINTFOLD Synergix Fold System Engineering Document Folder Synergix Fold System General informationMain components of the Model 2750 Folder Operator’s control panel Power entry module / counter / communications portMain control panel Bridge Instant service accessStacker/Handfeed Automatic document diversionManual feed slot Tower in normal folding and bypass modesStandard accordion fold packet Accordion folding overviewType F bookfold packet Folds handle easier than Z-folds Crossfolding overviewSEL = standard feed direction Key facts about fold programsLEL = non-standard feed direction Width sensors at input end of bridge Options available Main features of the 2750 folding systemPower entry panel After installationModel 2750 Folder operator’s side ½ x 11 C-folded packet, landscape style Operator’s controls12 Z-folded packet, portrait style BkaZ ½ x 11 book-folded packet Z fold onlyStart-up Fold Selection Host controllerFold Selection Standalone Reset procedureOn-line programs Hand feed programsRear of diverter tower, showing stacker/off-line components Manual document feedingHand feeding a document To begin hand feedingExiting Handfeed Mode Clearing a jam Jam conditionsIf the document is visible Bridge and Bridge ExitRaising the bridge lid Unlocking the bridgeTower Access to the towerRaising the bridge Accordion Folder Use the jog feature …Accordion folder lid in raised position Opening the upper clam shellRaising the drum faceplate shutter Using the crank handle to rotate the drumEjector springs on crank handle Crossfolder latches CrossfolderUpper section of the crossfolder in raised position Crossfold Pocket and Crossfold Exit Crossfold TransferCrossfolder rear panel Unhitching the accordion and cross folderCrank handle engaged in crossfold roll Interlock OpenCrossfold pocket System Error Accordion Folder Initial phase of the folding programIn-feed and accordion folding components Drum reversal develops a loop Panel measuring phaseCompletion of the first fold Accordion fold compensating panels Starting the second foldCrossfolder Document inversionFirst crossfold action Double crossfold mode Single crossfold modeSystem Menu Operator’s control panelCommunications mode PasswordsJog functions Parameter viewing and modificationDevice test Accessible only to the Key Operator and technicianActivity counters Recent errorsSheets 1s 3 0 5 Description 721p Synergix Fold System 40 & XES 2750 Series fold tablesAfnor Peco Fold MIX Fold BanksFold Bank 1 common European sizes Message Definition Location or type of error Folder Error Messages