Xerox 2750 manual Tower, Raising the bridge, Access to the tower

Page 23

Raising the bridge

The bridge is a precisely manufactured assembly. DO NOT use it as a seat or step, and DO NOT slam the bridge into its down or up positions! When returning the bridge to the down position, allow the bridge to engage gently the fixed stops inside the tower, then turn the knurled knob to lock the bridge in place.

4.Remove the document from the accordion folder in-feed rollers. If that isn’t possible, see “Accordion Folder” below. Lower and lock the bridge.

TOWER

To clear jams in the tower, use the recessed center handle to open the tower cover, then swing the inner sheet metal components GENTLY up to expose the hand feed and stacking paper paths. Clear all paths of paper, then close the tower to restart the folder.

Access to the tower

The entire upper section of the tower hinges open for access. Please handle it with care. DO NOT allow it to slam open or closed!

2750 op#2 R3.doc 10-02

Page 2-10

Image 23

Contents PRINTFOLD Synergix Fold System Engineering Document Folder Main components of the Model 2750 Folder General informationSynergix Fold System Operator’s control panel Power entry module / counter / communications portMain control panel Automatic document diversion Instant service accessBridge Stacker/HandfeedManual feed slot Tower in normal folding and bypass modesStandard accordion fold packet Accordion folding overviewType F bookfold packet Folds handle easier than Z-folds Crossfolding overviewLEL = non-standard feed direction Key facts about fold programsSEL = standard feed direction Width sensors at input end of bridge Options available Main features of the 2750 folding systemModel 2750 Folder operator’s side After installationPower entry panel BkaZ ½ x 11 book-folded packet Z fold only Operator’s controls½ x 11 C-folded packet, landscape style 12 Z-folded packet, portrait styleStart-up Fold Selection Host controllerHand feed programs Reset procedureFold Selection Standalone On-line programsRear of diverter tower, showing stacker/off-line components Manual document feedingHand feeding a document To begin hand feedingExiting Handfeed Mode Clearing a jam Jam conditionsUnlocking the bridge Bridge and Bridge ExitIf the document is visible Raising the bridge lidRaising the bridge Access to the towerTower Opening the upper clam shell Use the jog feature …Accordion Folder Accordion folder lid in raised positionEjector springs on crank handle Using the crank handle to rotate the drumRaising the drum faceplate shutter Upper section of the crossfolder in raised position CrossfolderCrossfolder latches Unhitching the accordion and cross folder Crossfold TransferCrossfold Pocket and Crossfold Exit Crossfolder rear panelCrossfold pocket Interlock OpenCrank handle engaged in crossfold roll System Error In-feed and accordion folding components Initial phase of the folding programAccordion Folder Completion of the first fold Panel measuring phaseDrum reversal develops a loop Accordion fold compensating panels Starting the second foldFirst crossfold action Document inversionCrossfolder Double crossfold mode Single crossfold modeSystem Menu Operator’s control panelParameter viewing and modification PasswordsCommunications mode Jog functionsDevice test Accessible only to the Key Operator and technicianSheets 1s 3 0 5 Recent errorsActivity counters Description 721p Synergix Fold System 40 & XES 2750 Series fold tablesAfnor Peco Fold MIX Fold BanksFold Bank 1 common European sizes Message Definition Location or type of error Folder Error Messages