Fujitsu fi-4750L manual Repositioning the Shipping Lock

Page 28

Repositioning the Shipping Lock

To keep the scanner from being damaged during shipping, the carrier unit is fixed with a Shipping Lock. After placing the carrier unit where it will be installed, change the position of this Shipping Lock as explained below.

1Place the image scanner on the edge of the desktop so that the left side of the scanner (where the ADF is attached) extends from the desktop. Do not set the image scanner upside down or on its side.

CAUTION

Do not let the scanner hang more than 20 cm (8 in.) over the edge of the desk.

Good

less than 20 cm (8 in.)

BadBad

2 Remove the shipping lock from position A . Then, install the shipping lock at position B .

Front side

Bottom view
Shipping Lock
(Position for storage,	ADF side
position for shipment)
Enlarged section A

Front side

Enlarged

Shipping Lock (Position for operation)

B

A

Shipping Lock (Position for shipment)

CAUTION

Before moving or storing the scanner, make sure that the shipping lock is set to the shipment position to prevent possible damage. Before setting the shipping lock, make sure that the carrier has been returned to the home position.

2-3

Image 28

Contents Fi-4750L Image Scanner Fi-4750L Image Scanner Revisions, Disclaimers Page Fujitsu Offices Fujitsu France S.APage Preface Conventions Contents Viii Terms Index Components Checking the Components Units and Assemblies Operator PanelChecking the Components Units Units and AssembliesFi-4750L Function Assemblies Operator Panel ArrangementButton/LED Function Name of the button FunctionCounter Display Counter FunctionOperation status Temporary error Alarm Page Page Installation and Connections Precautions Inspection Repositioning the Shipping Lock Connecting the power cable Turning the power switch OffCable Connections Connecting the interface cables Connecting the chute cableMounting the Stacker Setting the Scsi ID and the Scsi Terminator Page Operating Instruction Turning the Power On Waking up the Scanner from the Low Power Mode Manual Feed Mode Setting Loading Documents on the ADF ADFABD Documents Guide Guide lever Both sides Max 20 mm 0.8 or 10 mm 0.4 See Notices Scanner parts involved when loading documents Loading Documents on the FlatbedReading a Page from a Thick Book Page ADF Document Specification Scanner Maximum Minimum Document SizeFi-4750L A3/Double Letter A8 Portrait Paper weight PrecautionsDocument Quality Document typeMore than 30 mm Less than Feed direction Top of the paper ADF Document Feeder Capacity Country Unit ConversionAreas not to be Perforated Areas that must not be perforatedGrounding Color Areas Grounding color areaDouble Feed Detection Condition Job Separation Sheet Job separation sheetScanner Specifications Basic Product Specification Specification RemarksInstallation Specification SpecificationDimensions Page Consumables and Options Consumables Options Video Interface Option IPC-4D OptionName Specification Remarks ConsumablesOptions Name RemarksHow to Install the Video Interface Option Board Video Interface OptionPage Without IPC With IPC-4D Description Option Parameter DescriptionParameter Description IPC-4D Option Page Setup Mode Activating the Setup Mode Contents of the Setup ModeActivating the Setup Mode Contents of the Setup Mode Scsi ID Setting double feed detection Paper Thickness Setting double feed detection Paper Length Setting IPC pre-set mode Reset of the abrasion counter Setting the pick start timeSetting the time-out limit Page Scsi Terminator Setting Scsi ID SettingIPC Status Display Low Power Mode Setting Select Interface Display the TPS Board ID Number Select Built-In/IPC-4D Image ProcessingImage Processing M4097DAdjust ADF Erasing Edges Adjust FB Erasing Edges Page Glossary of Terms Double Letter Size IPC-4D Paper JAM TPS GL-6 Index Pick start time Declarations of Conformity DE-2