Fujitsu fi-4750L manual Contents of the Setup Mode

Contents of the Setup Mode

This section describes the contents of the setup mode.

No.	Item	Description	Selectable	Default
			parameters
		Specifies the double feed detection. Double
1	Double feed check	feed is detected by checking the document		No
		length and/or paper thickness.**
	Length check	Specifies the document length to enable	Tolerance:
2		double feed detection sets the document		No
	=No/10/15/20 mm		No/10/15/20mm
		length.
		Scanner automatically sets the	Document:
			No
		recommended reading parameters. 3 sets
3	IPC pre-setting		Sharpen Darken	No
		of parameters are available when IPC-4D is
			Charactor Copy
		not installed.
			Quality
4	Resetting of	Resets the abrasion counter.	-	-
	abrasion counter
	Pick start time	Specifies the time from document Insertion	Time:
5		to the start of picking. User can select the		1.0 sec
	setting		0.2 to 29.8 sec
		most comfortable Pick start time for the job.
		Specifies the time the scanner waits for the	Time:
6	Time-out limit setting	next document insertion after the last	27 values from	30 sec
		document was scanned.	1 to 1999 sec
	ADF front offset	Specifies the horizontal and vertical offset	Offset:	Offset:
7			H:-2 to +3 mm	H: 0 mm
	setting*	of the front side image when using the ADF.
			V:-2 to +3 mm	V: 0 mm
	ADF back offset	Specifies the horizontal and vertical offset	Offset:	Offset:
8		of the back side image when using the	H:-2 to +3 mm	H: 0 mm
	setting*
		ADF.	V:-2 to +3 mm	V: 0 mm
	Flatbed offset	Horizontal and vertical offset of the FB	Offset:	Offset:
9			H:-2 to +3 mm	H: 0 mm
	setting*	image is specified.
			V:-2 to +3 mm	V: 0 mm

7-2