Fujitsu fi-4750L manual Scsi ID

				(Continued)
No.	Item	Description	Selectable	Default
			parameters
10	IPC status display	The type of IPC option (IPC-4D) is
		displayed.
11	SCSI ID setting	The SCSI ID is selectable.	SCSI ID:	5
			0/1/2/3/4/5/6/7
12	SCSI terminator	Switch the SCSI terminator On/Off.	On/Off	On
	setting
13	Low Power Mode	Change the default setting of the duration	5 min.	15 min.
	setting	for power save.	to 60 min.
14	Select Interface	Select the interface when the scanner has	Auto/SCSI/Tps	Auto
		a board in the third party Slot.
15	Display TPS Board	Display the ID number of the board in the
	ID Number	third party Slot.
		When the IPC-4D image processing board
16	IPC mode	is installed in the third party slot, select this	Standard/IPC4D	Standard
		IPC-4D board or the image processing
		circuit built in the scanner.
			Left/Right:	Left/Right:
		Adjusts the edge areas to be erased from	0 to 15 mm	0 mm
			Top:	Top:
17	ADF Edge Erasing	the image scanned by the automatic
			0 to 15 mm	0 mm
		document feeder (ADF).
			Bottom:	Bottom:
			-7 to +7 mm	0 mm
			Left/Right:	Left/Right:
			0 to 15 mm	0 mm
18	FB Edge Erasing	Adjusts the edge areas to be erased from	Top:	Top:
		the image scanned by the flat bed (FB).	0 to 15 mm	0 mm
			Bottom:	Bottom:
			0 to 15 mm	0 mm

*This offset refers to the difference from the value adjusted by automatic offset adjustment.

**Some restrictions apply to the detection of a double feed.

7-3