Fujitsu fi-4750L manual Setting the Scsi ID and the Scsi Terminator

Page 32

Setting the SCSI ID and the SCSI Terminator

The default of the SCSI ID is 5. The SCSI ID is set by using the Setup mode of the operator panel. The procedure to change the SCSI ID is as follows:

1Turn the power On by

pressing the “I” side of the power switch. The scanner displays “Scanner Ready” on the lower line of the LCD.

2Press the “Next” button. The scanner displays “Mode select 1”.

NOTICE

If the scanner have a video interface option, the scanner displays “Mode Select 0” on the LCD.

3Press the “Next” button again. The scanner displays “Mode select 2” meaning that the setup mode is ready.

4Press the “Enter” button.

The scanner displays the following:

5Press the “Next” button ten. The scanner displays “SCSI ID” on the upper line of the LCD.

6Select the desired SCSI ID by pressing the “ ”or “” buttons, and then pressing “Enter” (the SCSI ID is set.)

7Press “Exit” to return to the “Scanner Ready” screen if you don’t need to change the terminator.

NOTICE

If no other device is using the same SCSI ID, the scanner ID does not have to be changed.

NOTICE

The new ID does not take effect until the system power is turned On again.

2-7

Image 32
Contents Fi-4750L Image Scanner Fi-4750L Image Scanner Revisions, Disclaimers Page Fujitsu Offices Fujitsu France S.APage Preface Conventions Contents Viii Terms Index Components Checking the Components Units and Assemblies Operator PanelChecking the Components Fi-4750L Units and AssembliesUnits Function Assemblies Operator Panel ArrangementButton/LED Function Name of the button FunctionCounter Display Counter FunctionOperation status Temporary error Alarm Page Page Installation and Connections Precautions Inspection Repositioning the Shipping Lock Cable Connections Turning the power switch OffConnecting the power cable Connecting the interface cables Connecting the chute cableMounting the Stacker Setting the Scsi ID and the Scsi Terminator Page Operating Instruction Turning the Power On Waking up the Scanner from the Low Power Mode Manual Feed Mode Setting Loading Documents on the ADF ADFABD Documents Guide Guide lever Both sides Max 20 mm 0.8 or 10 mm 0.4 See Notices Scanner parts involved when loading documents Loading Documents on the FlatbedReading a Page from a Thick Book Page ADF Document Specification Fi-4750L A3/Double Letter A8 Portrait Document SizeScanner Maximum Minimum Paper weight PrecautionsDocument Quality Document typeMore than 30 mm Less than Feed direction Top of the paper ADF Document Feeder Capacity Country Unit ConversionAreas not to be Perforated Areas that must not be perforatedGrounding Color Areas Grounding color areaDouble Feed Detection Condition Job Separation Sheet Job separation sheetScanner Specifications Basic Product Specification Specification RemarksInstallation Specification SpecificationDimensions Page Consumables and Options Consumables Options Video Interface Option IPC-4D OptionName Specification Remarks ConsumablesOptions Name RemarksHow to Install the Video Interface Option Board Video Interface OptionPage Without IPC With IPC-4D Description Option Parameter DescriptionParameter Description IPC-4D Option Page Setup Mode Activating the Setup Mode Contents of the Setup ModeActivating the Setup Mode Contents of the Setup Mode Scsi ID Setting double feed detection Paper Thickness Setting double feed detection Paper Length Setting IPC pre-set mode Reset of the abrasion counter Setting the pick start timeSetting the time-out limit Page IPC Status Display Scsi ID SettingScsi Terminator Setting Low Power Mode Setting Select Interface Display the TPS Board ID Number Select Built-In/IPC-4D Image ProcessingImage Processing M4097DAdjust ADF Erasing Edges Adjust FB Erasing Edges Page Glossary of Terms Double Letter Size IPC-4D Paper JAM TPS GL-6 Index Pick start time Declarations of Conformity DE-2