Fujitsu Siemens Computers X103 SFF manual Connecting the monitor, Connecting the mouse

Page 17

Preparing for use

Connecting the monitor

►Follow the instructions contained in the monitor manual to prepare the monitor for operation (e.g. connecting cables).

►Plug the data cable into the monitor port of the device.

►Plug the monitor power cable into the grounded mains outlet.

Connecting the mouse

Depending on the equipment level selected, your device will be supplied with a PS/2 mouse or a USB mouse.

Connecting a PS/2 mouse

►Connect the PS/2 mouse to the PS/2 mouse port of the device.

Connecting USB mouse

►Connect the USB mouse to the USB port of the device.

Connecting a keyboard

Depending on the equipment level selected, your device will be supplied with a standard keyboard or a USB keyboard.

Connecting standard keyboard

Use the supplied keyboard cable only.

►Plug the rectangular connector of the keyboard cable into the rectangular socket on the underside or on the rear of the keyboard.

►Plug the round plug of the keyboard cable into the keyboard port on the device.

Connecting USB keyboard

Use the supplied keyboard cable only.

►Plug the rectangular connector of the keyboard cable into the socket on the underside or on the rear of the keyboard.

►Insert the flat rectangular USB plug of the keyboard cable into a USB port of the device.

VFY-SCED103S, edition 1

9

Image 17

Contents Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Cleaning the device Safety notesImportant notes Transporting the deviceCE marking for devices without radio component Energy saving, disposal and recyclingCE marking Preparing for use Steps for initial setupUnpacking and checking the delivery External devicesSetting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboardConnecting a keyboard Connecting the monitorConnecting the mouse Initial switch-on Software will be installed Connecting the device to the mains voltageSwitching on monitor and device Connecting external devicesInstalling the software Connecting cablesPorts provided by the device Disconnecting cablesConnecting external devices to the USB ports Connecting external devices to the parallel or serial portPort settings Device driversPage Operation Switching the device onSwitching off the device Drive indicator, e.g. DVD Indicators provided by the deviceFloppy disk indicator Hard disk indicatorKeyboard ON/OFF switch optionalImportant keys and key combinations Enter keyMenu key Warm bootShift key Alt Gr e.g. German keyboardWorking with floppy disks Settings in Bios SetupPage Installing new software Troubleshooting and tipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Device cannot be switched off with the ON/OFF switchFloppy disk cannot be read or written No mouse pointer displayed on the screenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the hard disk contents Error messages on the screenTime and/or date is not correct TipsInformation about boards System expansionsClosing the casing Opening and closing the casingOpening the casing Assembling and dismantling low-profile units Installing a boardRemoving the holding plate Removing a boardRemoving the drive cage Inserting and removing the drive cageRemoving the cross-piece Removing the front panelAttaching the drive cage Installing the drive cageDisconnecting cables Removing the drive cage System expansions IDE drives and serial ATA drives Installing and removing drivesInstalling the cross-piece Installing and removing the hard disk Removing and installing accessible drivesSystem expansions Extensions to the mainboard Replacing lithium batteryMaking changes on mainboard Upgrading main memoryFollowing changes Page Dimensions Technical dataWeight Electrical dataPage Data IndexCable Index Scsi