Fujitsu Siemens Computers X103 SFF Operation, Switching the device on, Switching off the device

Page 23

Operation

Switching the device on

►If necessary, switch the monitor on (see the operating manual for the monitor).

►Press the ON/OFF switch on the front of the device.

The power-on indicator lights green and the device is started.

Switching off the device

►Shut down the operating system properly. For Windows: select Shut Down from the Start menu.

►If the operating system does not automatically switch the device into an energy-saving mode or switch it off, press the ON/OFF switch.

The device then consumes a minimum amount of energy.

	!	The ON/OFF switch does not disconnect the device from the mains voltage. To completely
	!	disconnect the mains voltage, remove the power plug from the socket.

► If necessary, switch the monitor off (see the operating manual for the monitor).

VFY-SCED103S, edition 1

Image 23

Contents Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Transporting the device Safety notesCleaning the device Important notesCE marking for devices without radio component Energy saving, disposal and recyclingCE marking External devices Steps for initial setupPreparing for use Unpacking and checking the deliverySetting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboardConnecting a keyboard Connecting the monitorConnecting the mouse Initial switch-on Software will be installed Connecting the device to the mains voltageConnecting cables Connecting external devicesSwitching on monitor and device Installing the softwarePorts provided by the device Disconnecting cablesDevice drivers Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Port settingsPage Operation Switching the device onSwitching off the device Hard disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Floppy disk indicatorEnter key ON/OFF switch optionalKeyboard Important keys and key combinationsAlt Gr e.g. German keyboard Warm bootMenu key Shift keyWorking with floppy disks Settings in Bios SetupPage Internal power supply overloaded Troubleshooting and tipsInstalling new software Mains voltage supply is faultyScreen stays blank Device cannot be switched off with the ON/OFF switchWrong RAM modules have been inserted No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong monitor has been set under Window XPTips Error messages on the screenRestoring the hard disk contents Time and/or date is not correctInformation about boards System expansionsClosing the casing Opening and closing the casingOpening the casing Removing a board Installing a boardAssembling and dismantling low-profile units Removing the holding plateRemoving the front panel Inserting and removing the drive cageRemoving the drive cage Removing the cross-pieceAttaching the drive cage Installing the drive cageDisconnecting cables Removing the drive cage System expansions IDE drives and serial ATA drives Installing and removing drivesInstalling the cross-piece Installing and removing the hard disk Removing and installing accessible drivesSystem expansions Upgrading main memory Replacing lithium batteryExtensions to the mainboard Making changes on mainboardFollowing changes Page Electrical data Technical dataDimensions WeightPage Data IndexCable Index Scsi