Fujitsu Siemens Computers X103 SFF manual Keyboard, Important keys and key combinations, Enter key

Page 25

 

 

 

 

Operation

Keyboard

 

 

 

 

 

1

 

2

 

 

 

 

 

3

 

4

5

1 =

Function keys

4 =

Cursor keys

 

2 = Power button (optional)

5 = Numeric keypad (calculator keypad)

3 = Alphanumeric keypad

i

The illustrated keyboard is an example and may differ from the model you use.

Important keys and key combinations

The description of the following keys and key combinations applies to Microsoft operating systems. Details of other keys and key combinations can be found in the documentation of the relevant application programme.

ON/OFF switch (optional)

Depending on the setting in the BIOS Setup, the system can be switched on, off, or on and off with this button. Some operating systems allow you to configure additional functions of the ON/OFF switch in the Control Panel.

With some keyboards the ON/OFF switch can only be used with an ACPI (Advanced Configuration and Power Management Interface). Otherwise the key is inoperative. The mainboard must support this function.

Enter key

confirms the marked selection. The enter key is also referred to as the "Return" key.

Start key

calls up the Windows Start menu.

VFY-SCED103S, edition 1

17

Image 25
Contents Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Cleaning the device Safety notesImportant notes Transporting the deviceCE marking Energy saving, disposal and recyclingCE marking for devices without radio component Preparing for use Steps for initial setupUnpacking and checking the delivery External devicesSetting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboardConnecting the mouse Connecting the monitorConnecting a keyboard Initial switch-on Software will be installed Connecting the device to the mains voltageSwitching on monitor and device Connecting external devicesInstalling the software Connecting cablesPorts provided by the device Disconnecting cablesConnecting external devices to the USB ports Connecting external devices to the parallel or serial portPort settings Device driversPage Switching off the device Switching the device onOperation Drive indicator, e.g. DVD Indicators provided by the deviceFloppy disk indicator Hard disk indicatorKeyboard ON/OFF switch optionalImportant keys and key combinations Enter keyMenu key Warm bootShift key Alt Gr e.g. German keyboardWorking with floppy disks Settings in Bios SetupPage Installing new software Troubleshooting and tipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Device cannot be switched off with the ON/OFF switchFloppy disk cannot be read or written No mouse pointer displayed on the screenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the hard disk contents Error messages on the screenTime and/or date is not correct TipsInformation about boards System expansionsOpening the casing Opening and closing the casingClosing the casing Assembling and dismantling low-profile units Installing a boardRemoving the holding plate Removing a boardRemoving the drive cage Inserting and removing the drive cageRemoving the cross-piece Removing the front panelDisconnecting cables Removing the drive cage Installing the drive cageAttaching the drive cage System expansions Installing the cross-piece Installing and removing drivesIDE drives and serial ATA drives Installing and removing the hard disk Removing and installing accessible drivesSystem expansions Extensions to the mainboard Replacing lithium batteryMaking changes on mainboard Upgrading main memoryFollowing changes Page Dimensions Technical dataWeight Electrical dataPage Cable IndexData Index Scsi