Fujitsu Siemens Computers X103 SFF manual Technical data, Electrical data, Dimensions, Weight

Page 45

Technical data

Electrical data

 

Regulations complied with:

IEC60950-1/EN60950-1

Protection class:

I

Rated voltage range:

100 - 127 / 200 - 240 V

Frequency:

47 Hz - 63 Hz

Dimensions

 

Width/depth/height:

333 mm/370 mm/100 mm

Weight

 

with the basic configuration

approx. 10 kg

Environmental conditions

 

Environment class (3K2)

DIN IEC 721 part 3-3

Environment class (2K2)

DIN IEC 721 part 3-2

Temperature:

15 °C .... 35 °C

Operating (3K2)

-25 °C .... 60 °C

Transport (2K2)

Condensation in operating must be avoided.

Clearance required to ensure adequate ventilation

Horizontal operating position:

front

min. 200 mm

rear

min. 200 mm

left

min. 200 mm

right-hand side

min. 200 mm

Vertical operating position:

 

front

min. 200 mm

rear

min. 200 mm

top

min. 200 mm

i

The data sheet of the device contains further technical data. You will find the data sheet

on the internet at www.fujitsu-siemens.com.

 

VFY-SCED103S, edition 1

37

Image 45
Contents Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Cleaning the device Safety notesImportant notes Transporting the deviceEnergy saving, disposal and recycling CE markingCE marking for devices without radio component Preparing for use Steps for initial setupUnpacking and checking the delivery External devicesSetting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboardConnecting the monitor Connecting the mouseConnecting a keyboard Initial switch-on Software will be installed Connecting the device to the mains voltageSwitching on monitor and device Connecting external devicesInstalling the software Connecting cablesPorts provided by the device Disconnecting cablesConnecting external devices to the USB ports Connecting external devices to the parallel or serial portPort settings Device driversPage Switching the device on Switching off the deviceOperation Drive indicator, e.g. DVD Indicators provided by the deviceFloppy disk indicator Hard disk indicatorKeyboard ON/OFF switch optionalImportant keys and key combinations Enter keyMenu key Warm bootShift key Alt Gr e.g. German keyboardWorking with floppy disks Settings in Bios SetupPage Installing new software Troubleshooting and tipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Device cannot be switched off with the ON/OFF switchFloppy disk cannot be read or written No mouse pointer displayed on the screenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the hard disk contents Error messages on the screenTime and/or date is not correct TipsInformation about boards System expansionsOpening and closing the casing Opening the casingClosing the casing Assembling and dismantling low-profile units Installing a boardRemoving the holding plate Removing a boardRemoving the drive cage Inserting and removing the drive cageRemoving the cross-piece Removing the front panelInstalling the drive cage Disconnecting cables Removing the drive cageAttaching the drive cage System expansions Installing and removing drives Installing the cross-pieceIDE drives and serial ATA drives Installing and removing the hard disk Removing and installing accessible drivesSystem expansions Extensions to the mainboard Replacing lithium batteryMaking changes on mainboard Upgrading main memoryFollowing changes Page Dimensions Technical dataWeight Electrical dataPage Index CableData Index Scsi