Fujitsu Siemens Computers X103 SFF manual Installing the drive cage, Attaching the drive cage

Page 37

System expansions

Disconnecting cables

Removing the drive cage

►Lift the drive cage slightly and disconnect the wires from the drives.

►Lift the drive cage into a vertical position (1).

►Pull the drive cage out of the casing in the direction of the arrow (2).

Installing the drive cage

The following steps should be taken when assembling the drive cage:

Attaching the drive cage

►Place the drive cage onto the front of the casing. Feed the latches (1) into the corresponding slits (2).

VFY-SCED103S, edition 1

Image 37

Contents Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Cleaning the device Safety notesImportant notes Transporting the deviceCE marking Energy saving, disposal and recyclingCE marking for devices without radio component Preparing for use Steps for initial setupUnpacking and checking the delivery External devicesSetting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboardConnecting the mouse Connecting the monitorConnecting a keyboard Initial switch-on Software will be installed Connecting the device to the mains voltageSwitching on monitor and device Connecting external devicesInstalling the software Connecting cablesPorts provided by the device Disconnecting cablesConnecting external devices to the USB ports Connecting external devices to the parallel or serial portPort settings Device driversPage Switching off the device Switching the device onOperation Drive indicator, e.g. DVD Indicators provided by the deviceFloppy disk indicator Hard disk indicatorKeyboard ON/OFF switch optionalImportant keys and key combinations Enter keyMenu key Warm bootShift key Alt Gr e.g. German keyboardWorking with floppy disks Settings in Bios SetupPage Installing new software Troubleshooting and tipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Device cannot be switched off with the ON/OFF switchFloppy disk cannot be read or written No mouse pointer displayed on the screenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the hard disk contents Error messages on the screenTime and/or date is not correct TipsInformation about boards System expansionsOpening the casing Opening and closing the casingClosing the casing Assembling and dismantling low-profile units Installing a boardRemoving the holding plate Removing a boardRemoving the drive cage Inserting and removing the drive cageRemoving the cross-piece Removing the front panelDisconnecting cables Removing the drive cage Installing the drive cageAttaching the drive cage System expansions Installing the cross-piece Installing and removing drivesIDE drives and serial ATA drives Installing and removing the hard disk Removing and installing accessible drivesSystem expansions Extensions to the mainboard Replacing lithium batteryMaking changes on mainboard Upgrading main memoryFollowing changes Page Dimensions Technical dataWeight Electrical dataPage Cable IndexData Index Scsi