Fujitsu Siemens Computers X103 SFF Assembling and dismantling low-profile units, Removing a board

Page 35

System expansions

Assembling and dismantling low-profile units

	!	Do not dispose of the slot cover. If you remove the board again, you must reinstall the slot
	!	cover (cooling, fire protection or EMC regulations to be complied with).

Removing the holding plate

►Open the casing (see "Opening the casing").

►Undo the screws (1) and remove the holding plate (2).

Installing a board

►Push the board up to its slot as far as the stop.

►Press the board into the slot so that it engages.

►If necessary, plug the lines on the board again.

Removing a board

►Disconnect the cables connected to the board.

►Pull the board out of the slot.

Re-assembling the holding plate

►Position the holding plate (2) so that it secures the components.

►Screw in the screws (1) previously removed again.

VFY-SCED103S, edition 1

Image 35

Contents Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Transporting the device Safety notesCleaning the device Important notesCE marking for devices without radio component Energy saving, disposal and recyclingCE marking External devices Steps for initial setupPreparing for use Unpacking and checking the deliverySetting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboardConnecting a keyboard Connecting the monitorConnecting the mouse Initial switch-on Software will be installed Connecting the device to the mains voltageConnecting cables Connecting external devicesSwitching on monitor and device Installing the softwarePorts provided by the device Disconnecting cablesDevice drivers Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Port settingsPage Operation Switching the device onSwitching off the device Hard disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Floppy disk indicatorEnter key ON/OFF switch optionalKeyboard Important keys and key combinationsAlt Gr e.g. German keyboard Warm bootMenu key Shift keyWorking with floppy disks Settings in Bios SetupPage Internal power supply overloaded Troubleshooting and tipsInstalling new software Mains voltage supply is faultyScreen stays blank Device cannot be switched off with the ON/OFF switchWrong RAM modules have been inserted No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong monitor has been set under Window XPTips Error messages on the screenRestoring the hard disk contents Time and/or date is not correctInformation about boards System expansionsClosing the casing Opening and closing the casingOpening the casing Removing a board Installing a boardAssembling and dismantling low-profile units Removing the holding plateRemoving the front panel Inserting and removing the drive cageRemoving the drive cage Removing the cross-pieceAttaching the drive cage Installing the drive cageDisconnecting cables Removing the drive cage System expansions IDE drives and serial ATA drives Installing and removing drivesInstalling the cross-piece Installing and removing the hard disk Removing and installing accessible drivesSystem expansions Upgrading main memory Replacing lithium batteryExtensions to the mainboard Making changes on mainboardFollowing changes Page Electrical data Technical dataDimensions WeightPage Data IndexCable Index Scsi