Fujitsu Siemens Computers X103 SFF Inserting and removing the drive cage, Removing the drive cage

Page 36

System expansions

Inserting and removing the drive cage

Removing the drive cage

The following steps should be taken when dismantling the drive cage:

Removing the cross-piece

►Open the casing (see "Opening the casing").

►Undo both screws (1) and remove the cross-beam (2) from the casing.

Removing the front panel

1		1		1

►Undo the lugs (1) and carefully remove the front panel.

Unscrewing the metal frame

►Remove the two screws (1).

28	VFY-SCED103S, edition 1

Image 36

Contents Edition X103 SFF Are there Page Published by Edition X103 SFF Operating ManualPage Contents Contents Your Edition X103 SFF Notational conventionsPage Safety notes Cleaning the deviceImportant notes Transporting the deviceEnergy saving, disposal and recycling CE markingCE marking for devices without radio component Steps for initial setup Preparing for useUnpacking and checking the delivery External devicesSetting up the device Vertical operating position Connect the monitor, mouse and keyboard Horizontal operating position with rubber feetConnecting the monitor Connecting the mouseConnecting a keyboard Connecting the device to the mains voltage Initial switch-on Software will be installedConnecting external devices Switching on monitor and deviceInstalling the software Connecting cablesDisconnecting cables Ports provided by the deviceConnecting external devices to the parallel or serial port Connecting external devices to the USB portsPort settings Device driversPage Switching the device on Switching off the deviceOperation Indicators provided by the device Drive indicator, e.g. DVDFloppy disk indicator Hard disk indicatorON/OFF switch optional KeyboardImportant keys and key combinations Enter keyWarm boot Menu keyShift key Alt Gr e.g. German keyboardSettings in Bios Setup Working with floppy disksPage Troubleshooting and tips Installing new softwareMains voltage supply is faulty Internal power supply overloadedDevice cannot be switched off with the ON/OFF switch Screen stays blankNo mouse pointer displayed on the screen Floppy disk cannot be read or writtenWrong monitor has been set under Window XP Wrong RAM modules have been insertedError messages on the screen Restoring the hard disk contentsTime and/or date is not correct TipsSystem expansions Information about boardsOpening and closing the casing Opening the casingClosing the casing Installing a board Assembling and dismantling low-profile unitsRemoving the holding plate Removing a boardInserting and removing the drive cage Removing the drive cageRemoving the cross-piece Removing the front panelInstalling the drive cage Disconnecting cables Removing the drive cageAttaching the drive cage System expansions Installing and removing drives Installing the cross-pieceIDE drives and serial ATA drives Removing and installing accessible drives Installing and removing the hard diskSystem expansions Replacing lithium battery Extensions to the mainboardMaking changes on mainboard Upgrading main memoryFollowing changes Page Technical data DimensionsWeight Electrical dataPage Index CableData Index Scsi