Fujitsu Siemens Computers X103 SFF manual Following changes

Page 43

System expansions

The lithium battery holder exists in different designs that function in the same way.

►Press the catch in the direction of the arrow (1). The battery jumps out of the holder slightly.

►Remove the battery (2).

►Push the new lithium battery of the identical type into the holder and press it downward until it engages.

Following changes

►If necessary, install the drive cage again (see "Installing the drive cage").

►Reinstall the cross-piece (see "Installing the cross-piece").

►Close the casing (see "Closing the casing").

VFY-SCED103S, edition 1

Image 43

Contents Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Transporting the device Safety notesCleaning the device Important notesCE marking Energy saving, disposal and recyclingCE marking for devices without radio component External devices Steps for initial setupPreparing for use Unpacking and checking the deliverySetting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboardConnecting the mouse Connecting the monitorConnecting a keyboard Initial switch-on Software will be installed Connecting the device to the mains voltageConnecting cables Connecting external devicesSwitching on monitor and device Installing the softwarePorts provided by the device Disconnecting cablesDevice drivers Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Port settingsPage Switching off the device Switching the device onOperation Hard disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Floppy disk indicatorEnter key ON/OFF switch optionalKeyboard Important keys and key combinationsAlt Gr e.g. German keyboard Warm bootMenu key Shift keyWorking with floppy disks Settings in Bios SetupPage Internal power supply overloaded Troubleshooting and tipsInstalling new software Mains voltage supply is faultyScreen stays blank Device cannot be switched off with the ON/OFF switchWrong RAM modules have been inserted No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong monitor has been set under Window XPTips Error messages on the screenRestoring the hard disk contents Time and/or date is not correctInformation about boards System expansionsOpening the casing Opening and closing the casingClosing the casing Removing a board Installing a boardAssembling and dismantling low-profile units Removing the holding plateRemoving the front panel Inserting and removing the drive cageRemoving the drive cage Removing the cross-pieceDisconnecting cables Removing the drive cage Installing the drive cageAttaching the drive cage System expansions Installing the cross-piece Installing and removing drivesIDE drives and serial ATA drives Installing and removing the hard disk Removing and installing accessible drivesSystem expansions Upgrading main memory Replacing lithium batteryExtensions to the mainboard Making changes on mainboardFollowing changes Page Electrical data Technical dataDimensions WeightPage Cable IndexData Index Scsi