Fujitsu Siemens Computers X103 SFF manual System expansions

Page 38

System expansions

Inserting the wires

Securing the metal frame

Attaching the front panel


1	1	1

►Lower the drive cage slightly and re-insert the wires into the drives.

►Lower the drive cage as far as it will go. Be careful that no wires become trapped.

►Screw in the screws (1) previously removed again.

►Carefully place the front panel onto the front of the casing, until the lugs (1) engage.

30	VFY-SCED103S, edition 1

Image 38

Contents Edition X103 SFF Are there Page Published by Edition X103 SFF Operating ManualPage Contents Contents Your Edition X103 SFF Notational conventionsPage Important notes Safety notesCleaning the device Transporting the deviceCE marking for devices without radio component Energy saving, disposal and recyclingCE marking Unpacking and checking the delivery Steps for initial setupPreparing for use External devicesSetting up the device Vertical operating position Connect the monitor, mouse and keyboard Horizontal operating position with rubber feetConnecting a keyboard Connecting the monitorConnecting the mouse Connecting the device to the mains voltage Initial switch-on Software will be installedInstalling the software Connecting external devicesSwitching on monitor and device Connecting cablesDisconnecting cables Ports provided by the devicePort settings Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Device driversPage Operation Switching the device onSwitching off the device Floppy disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Hard disk indicatorImportant keys and key combinations ON/OFF switch optionalKeyboard Enter keyShift key Warm bootMenu key Alt Gr e.g. German keyboardSettings in Bios Setup Working with floppy disksPage Mains voltage supply is faulty Troubleshooting and tipsInstalling new software Internal power supply overloadedDevice cannot be switched off with the ON/OFF switch Screen stays blankWrong monitor has been set under Window XP No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong RAM modules have been insertedTime and/or date is not correct Error messages on the screenRestoring the hard disk contents TipsSystem expansions Information about boardsClosing the casing Opening and closing the casingOpening the casing Removing the holding plate Installing a boardAssembling and dismantling low-profile units Removing a boardRemoving the cross-piece Inserting and removing the drive cageRemoving the drive cage Removing the front panelAttaching the drive cage Installing the drive cageDisconnecting cables Removing the drive cage System expansions IDE drives and serial ATA drives Installing and removing drivesInstalling the cross-piece Removing and installing accessible drives Installing and removing the hard diskSystem expansions Making changes on mainboard Replacing lithium batteryExtensions to the mainboard Upgrading main memoryFollowing changes Page Weight Technical dataDimensions Electrical dataPage Data IndexCable Index Scsi