Fujitsu Siemens Computers X103 SFF manual Connecting the device to the mains voltage

Page 18

Connecting the device to the mains voltage

100 V - 125 V	► Check the voltage setting.

	!	The visible value must agree with the local mains voltage:
		115 = 100 V to 127 V	230 = 200 V to 240 V

If an incorrect mains voltage is set, push the slide switch all the way into the other position with a pointed object.

You may only operate the device, if the voltage for the device is set to the local mains voltage.

2

1

►Connect the power cable to the device (1).

►Plug the power plug into a grounded mains outlet (2).

Initial switch-on: Software will be installed

If the device is integrated into a network, the user and server details as well as the network protocol are required during the software installation. Contact your network administrator if you have any questions about these settings.

When you switch on the device for the first time, the supplied software is installed and configured. Plan a reasonable amount of time for this, as this process must not be interrupted.

	!	Once the installation has been started the device must not be switched off, unless the
	!	installation has been completed.
		installation has been completed.

During installation, the device may only be rebooted when you are requested to do so!

The installation will otherwise not be carried out correctly and the contents of the hard disk must be completely restored.

You may need the licence number for Windows during the installation. The licence number is located on a sticker on your device.

10	VFY-SCED103S, edition 1

Image 18

Contents Edition X103 SFF Are there Page Published by Edition X103 SFF Operating ManualPage Contents Contents Your Edition X103 SFF Notational conventionsPage Important notes Safety notesCleaning the device Transporting the deviceEnergy saving, disposal and recycling CE markingCE marking for devices without radio component Unpacking and checking the delivery Steps for initial setupPreparing for use External devicesSetting up the device Vertical operating position Connect the monitor, mouse and keyboard Horizontal operating position with rubber feetConnecting the monitor Connecting the mouseConnecting a keyboard Connecting the device to the mains voltage Initial switch-on Software will be installedInstalling the software Connecting external devicesSwitching on monitor and device Connecting cablesDisconnecting cables Ports provided by the devicePort settings Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Device driversPage Switching the device on Switching off the deviceOperation Floppy disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Hard disk indicatorImportant keys and key combinations ON/OFF switch optionalKeyboard Enter keyShift key Warm bootMenu key Alt Gr e.g. German keyboardSettings in Bios Setup Working with floppy disksPage Mains voltage supply is faulty Troubleshooting and tipsInstalling new software Internal power supply overloadedDevice cannot be switched off with the ON/OFF switch Screen stays blankWrong monitor has been set under Window XP No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong RAM modules have been insertedTime and/or date is not correct Error messages on the screenRestoring the hard disk contents TipsSystem expansions Information about boardsOpening and closing the casing Opening the casingClosing the casing Removing the holding plate Installing a boardAssembling and dismantling low-profile units Removing a boardRemoving the cross-piece Inserting and removing the drive cageRemoving the drive cage Removing the front panelInstalling the drive cage Disconnecting cables Removing the drive cageAttaching the drive cage System expansions Installing and removing drives Installing the cross-pieceIDE drives and serial ATA drives Removing and installing accessible drives Installing and removing the hard diskSystem expansions Making changes on mainboard Replacing lithium batteryExtensions to the mainboard Upgrading main memoryFollowing changes Page Weight Technical dataDimensions Electrical dataPage Index CableData Index Scsi