Fujitsu Siemens Computers X103 SFF manual Vertical operating position

Page 15

Preparing for use

Vertical operating position

Proceed as follows to operate the device in the vertical operating position:

► If necessary, disconnect the cables.

Use the base feet contained in the accessory pack when it is to be used in a vertical position:

► Place the feet of the device on a non-slip surface.

► Place the device on the base feet (see illustration).

► If necessary, reconnect the cables.

	!	The set-up direction is specified. The ON/OFF switch must be at the top to ensure
	!	sufficient ventilation.
		sufficient ventilation.

The vertical operating position is only permissible with base feet. The base feet provide for sufficient ventilation on the underside of the device.

VFY-SCED103S, edition 1

Image 15

Contents Edition X103 SFF Are there Page Published by Operating Manual Edition X103 SFFPage Contents Contents Notational conventions Your Edition X103 SFFPage Transporting the device Safety notesCleaning the device Important notesEnergy saving, disposal and recycling CE markingCE marking for devices without radio component External devices Steps for initial setupPreparing for use Unpacking and checking the deliverySetting up the device Vertical operating position Horizontal operating position with rubber feet Connect the monitor, mouse and keyboardConnecting the monitor Connecting the mouseConnecting a keyboard Initial switch-on Software will be installed Connecting the device to the mains voltageConnecting cables Connecting external devicesSwitching on monitor and device Installing the softwarePorts provided by the device Disconnecting cablesDevice drivers Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Port settingsPage Switching the device on Switching off the deviceOperation Hard disk indicator Indicators provided by the deviceDrive indicator, e.g. DVD Floppy disk indicatorEnter key ON/OFF switch optionalKeyboard Important keys and key combinationsAlt Gr e.g. German keyboard Warm bootMenu key Shift keyWorking with floppy disks Settings in Bios SetupPage Internal power supply overloaded Troubleshooting and tipsInstalling new software Mains voltage supply is faultyScreen stays blank Device cannot be switched off with the ON/OFF switchWrong RAM modules have been inserted No mouse pointer displayed on the screenFloppy disk cannot be read or written Wrong monitor has been set under Window XPTips Error messages on the screenRestoring the hard disk contents Time and/or date is not correctInformation about boards System expansionsOpening and closing the casing Opening the casingClosing the casing Removing a board Installing a boardAssembling and dismantling low-profile units Removing the holding plateRemoving the front panel Inserting and removing the drive cageRemoving the drive cage Removing the cross-pieceInstalling the drive cage Disconnecting cables Removing the drive cageAttaching the drive cage System expansions Installing and removing drives Installing the cross-pieceIDE drives and serial ATA drives Installing and removing the hard disk Removing and installing accessible drivesSystem expansions Upgrading main memory Replacing lithium batteryExtensions to the mainboard Making changes on mainboardFollowing changes Page Electrical data Technical dataDimensions WeightPage Index CableData Index Scsi